English
(3) Configuring RAID set in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step and proceed to Section 4 if you do not want to create RAID.
Step 1:
After the POST memory test begins and before the operating system boot begins, the following information will appear on screen (Figure 3). Press the TAB key to enter the VT8237 Serial ATA RAID BIOS configuration utility.
VIA Technologies, Inc. VIA VT8237 Serial ATA RAID BIOS Setting Utility V4.97
Copyright (C) VIA Technologies, Inc. All Right reserved.
Scan Devices, Please wait...
Press <Tab> key into User Window!
Serial_Ch0 Master : ST3120026AS
Serial_Ch1 Master : ST3120026AS
Figure 3
Step 2:
In the VT8237 SATA RAID BIOS utility screen (Figure 4), you can use the UP or DOWN ARROW key to highlight through choices. Highlight an item that you want to execute and press ENTER.
VIA Tech. VT8237 SATA RAID BIOS Ver 4.97
Create Array |
| Create a RAID array with | ||
Delete Array |
| the hard disks attached to | ||
Create/Delete Spare | VIA RAID controller | |||
Select Boot Array | F1 | : | View Array/disk Status | |
Serial Number View | ||||
|
| , | : Move to next item | |
|
| Enter | : | Confirm the selection |
|
| ESC | : | Exit |
Channel | Drive Name | Array Name | Mode | Size(GB) | Status |
Serial_Ch0 Master | ST3120026AS |
| SATA | 111.79 | Hdd |
Serial_Ch1 Master | ST3120026AS |
| SATA | 111.79 | Hdd |
Figure 4
- 64 - |