Gigabyte GA-8IP775 Series user manual I/O Back Panel Introduction

Page 17

1-6 I/O Back Panel Introduction

(*)

PS/2 Keyboard and PS/2 Mouse Connector

To install a PS/2 port keyboard and mouse, plug the mouse to the upper port(green) and the keyboard to the lower port (purple).

Parallel Port

The parallel port allows connection of a printer, scanner and other peripheral devices.

/ COM A/COM B (Serial Port)

Connects to serial-based mouse or data processing devices.

USB port

Before you connectyour device(s) into USB connector(s), please make sure your device(s) such as USB keyboard, mouse, scanner, zip, speaker...etc. have a standard USB interface.

Also make sure your OS supports USB controller . If your OS does not support USB controller, please contact OS vendor for possible patch or driver upgrade. For more information please contact your OS or device(s) vendors.

LAN Port (*)

The provided Internet connection is Gigabit Ethernet, providing data transfer speeds of 10/100/1000Mbps.

Line In

Devices like CD-ROM, walkman etc. can be connected to Line In jack.

Line Out

Connect the stereo speakers, earphone or front surround channels to this connector.

MIC In

Microphone can be connected to MIC In jack.

You can use audio software to configure 2-/4-/6-/8- channel audio functioning.

(*) Only for GA-8IP775-G.

English

- 17 -

Hardware Installation

Image 17
Contents GA-8IP775 Series Motherboard Product Manual Classification CopyrightTable of Contents Install Drivers P4 Titan GA-8IP775-GBlock Diagram Page Installation Notices Considerations Prior to InstallationInstances of Non-Warranty Preparing Your ComputerCPU Feature SummaryBios Installation of the CPU Installation of the CPU and HeatsinkInstallation of the Heatsink DDR Installation of MemoryDual Channel DDR Installation of Expansion Cards I/O Back Panel Introduction Connectors Introduction ATX12V/ATX Power Connector IDE1/IDE2 IDE Connector Cpufan / Sysfan Cooler Fan Power ConnectorSATA0/SATA1 Serial ATA Connector FDD Floppy ConnectorFpanel Front Panel Jumper PwrledSurcen Faudio Front Audio ConnectorSpdifio Spdif In/Out Cdin CDIrcir USB1 / FUSB2 Front USB ConnectorInfolink Game Game ConnectorClrcmos Clear Cmos CI Chassis Intrusion, Case OpenBATBattery Main Menu Status Page Setup Menu / Option Page Setup MenuMain Menu For example Bios Ver. E2 „ Set User Password „ Set Supervisor Password„ Save & Exit Setup „ Exit Without SavingIDE Channel 0 Master, Slave/IDE Channel 1 Master, Slave Standard Cmos FeaturesTime Drive a / Drive B Floppy 3 Mode Support for Japan AreaHalt on MemoryHard Disk Boot Priority Advanced Bios FeaturesFirst / Second / Third Boot Device Password CheckLimit Cpuid Max. to CPU Hyper-ThreadingOn-Chip Secondary PCI IDE Integrated PeripheralsOn-Chip Primary PCI IDE Sata Port1 Configure as Sata Port0 Configure asOnboard LAN Boot ROM On-chip SataUR2 Duplex Mode Uart Mode SelectParallel Port Mode ECP Mode Use DMAMidi Port Address Game Port AddressMidi Port IRQ CIR Port AddressModemRingOn/WakeOnLAN Power Management SetupPower On By Mouse Resume by AlarmPower On By Keyboard KB Power on PasswordPCI 1/PCI 5 IRQ Assignment PnP/PCI ConfigurationsPC Health Status CPU FAN PIN Type CPU Smart FAN ControlCPU Clock Ratio Frequency/Voltage ControlCPU Host Clock Control CPU Host Frequency MhzMemory Frequency Mhz Memory Frequency ForAGP/PCI/SRC Frequency Mhz Dimm OverVoltage ControlLoad Optimized Defaults Load Fail-Safe DefaultsSet Supervisor/User Password Exit Without Saving Save & Exit SetupEnglish Install Chipset Drivers Install DriversDriver CD Information Software ApplicationsContact Us Hardware InformationEnglish What is Xpress Recovery ? Xpress Recovery IntroductionHow to use the Xpress Recovery Unique Software UtilitiesF9 For Xpress Recovery Exit and Restart Remove Backup Image  Remove backup image. Are you sure? Y/NBefore You Begin Flash Bios Method IntroductionMethod 1 Q-FlashTMUtility Task menu for Dual Bios utility Exploring the Q-FlashTM / Dual Bios utility screenEntering the Q-FlashTMutility Task menu for Q-Flash utilitySteps Using the Q-FlashTMutilityYou can repeat to 4 to flash the backup BIOS, too Part Two FlashTMutility bar Exploring the Q-FlashTMutility screenCongratulation!! You have updated Bios successfully Methods and steps Method 2 @BIOSTM UtilityEnglish 3 2 / 4 / 6 / 8 Channel Audio Function Introduction Stereo Speakers Connection and SettingsChannel Analog Audio Output Mode English Channel Audio Setup using Audio Combo Kit, Optional Device English Spdif Output Device Optional Device Jack-Sensing and UAJ Introduction English Troubleshooting English English English Taiwan Headquarters Contact UsChina Shanghai