Press ENT again and the LCD will prompt you to conrm the erase operation.
All data will be lost,Erase? No
Full Erase HDD
This function is used to full erase all data on the HDD. Please backup any important data before using this function.
|
|
| ||
|
| Full Erase HDD |
| |
|
|
|
|
|
Press | ENT to enter the following screen. Use the Up and Down buttons to select the HDD to | |||
erase. |
|
|
|
|
|
|
|
| |
|
| Quick Erase HDD |
| |
|
| ALL/Target CH:* |
| |
|
|
|
| |
Press | ENT again and the LCD will prompt you to conrm the erase operation. | |||
|
|
| ||
|
| All data will be |
| |
|
| lost,Erase? No |
| |
|
|
| ||
H/W Diagnostic | ||||
Press | ENT to enter the following screen. This function is used to check that the system is | |||
operating normally. | ||||
|
|
| ||
|
|
| ||
|
| H/W Diagnostic |
| |
|
|
|
| |
Press | ENT again to enter the following screen. The LCD will cycle through the test categories as | |||
they are performed. The LCD display is tested rst, the control panel is tested next (requires manual operation), then followed by the system's internal diagnostics, hardware connection test then the RAM and SD Flash test. All test results are shown on the LCD. This is a simple way to verify that the system is operating normally.
Press ENT and the system will begin the tests as shown below.
LCD Test Start |
|
|
|
| Button Test ? |
|
|
|
|
|
|
|
|
|
|
|
|
Test IDE 0/1 |
|
|
|
| FlashTest: OK |
OK |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SDRAM Test: 8192Kbytes OK
Test nished
Once the system diagnostics have been completed the "Test finished" message will appear on the LCD.
www.addonics.com
Technical Support | Phone: | Email: www.addonics.com/support/query/ |