Addonics Technologies HDU11SITDR manual Tolerance Size, BootTime Delay, Quick Compare

Press ENT to enter the following ￿gure. The default is O￿. Use the Up and Down arrow keys to choose 5 Sec-50 Sec.

Auto Start Timer

O￿

Tolerance Size

This option is used to set the tolerance in terms of percentage di￿erence between the source and target capacity. This is to ensure that when the target drive is smaller than the source drive, the duplication process will not start.

10-11. Setup

Tolerance Size

Press ENT to enter the following ￿gure. The default is O￿. Use the Up and Down arrow keys to choose 1MB~100MB of source.

Tolerance Size 1MB

BootTime Delay

This option is used to to set boot delay time.

10-12. Setup

BootTime Delay

Press ENT to enter the following ￿gure. The default is 5 sec. Use the Up and Down arrow keys to choose 0~99 sec.

BootTime Delay 5 sec

Quick Compare

This option is used to set the size of each comparison unit.

10-13. Setup

Quick Compare

Press ENT to enter the following ￿gure. The default is O￿. Use the Up and Down arrow keys to choose 1 Byte/1K/10K/100K/1MB/10MB/100 Mbytes. (In order to improve the accuracy of pure data can maintain the default settings.)

Quick Compare

O￿

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/