U s i n g | t h e | P r o j e c t o r |
|
|
|
NOTE: For model
Scribble 
The scribble button activates
1Press the scribble button. The cursor changes to a pencil.
2Press the right disk mouse button (Figure 20 on page 25) to display the color selector. Use the disk mouse to position the cursor on the desired color, then press the left mouse button. Press the right button again to close the color selector.
3Use the disk mouse to move the pencil to where you want to start the annotation.
4Press the left mouse button. The cursor changes to an upright pencil.
5Use the disk mouse to draw your annotation. Press the left mouse button to complete the annotation.
6To exit Scribble, press the scribble button. The annotation is automatically deleted (it cannot be saved).
Power 
The Power button turns the projector on and off, and functions the same on the keypad and remote. When you press power while the projector is on, the lamp stays on for 15 seconds before shutting off. If you press power again within 15 seconds, the pro- jector returns to normal operation immediately. If you don’t press power again, the lamp turns off after 15 seconds. The fan contin- ues to run until the projector has cooled (approximately 30 sec- onds).
Video 1 and 2 
When you have more than one source (computer or video) con- nected to the projector, select between them by pressing the but- ton for the source you want.
Press video 1 or 2 to display the image from your video player.
24