M a i n t e n a n c e | a n d | T r o u b l e s h o o t i n g |
|
|
|
WARNING: Do not drop the lamp module or touch the glass bulb! The glass may shatter and cause injury.
FIGURE 29
Removing the lamp module
7Align the new lamp module in the correct direction.
8Gently push the module in as far as it goes.
9Tighten the screws on the outside of the module.
10Reposition the lamp cover.
11Replace the screw and tighten it.
12Plug in the power cord and turn the projector back on.
13To reset the lamp hour counter in the Status bar, press and hold the left mouse button, then press the menu button (while still holding down the mouse button) for 5 seconds. Verify that the counter was reset by pressing the menu button and viewing the counter (see page 26).
38