Apple 9000 manual Safety Summary, Do Not Look Into The Lens, Power Source, Power Cord

Page 7

SAFETY SUMMARY

Please read these instructions carefully before using your projec- tor. Failure to comply with them could result in fire, electrical shock, personal injury or damage to equipment.

These graphics are used throughout this manual to draw your attention to important information about the projectors.

NOTE: Additional useful details or tips.

CAUTION: Steps to take to avoid damage to your equipment.

WARNING: Steps to take to avoid personal injury.

These graphics are used on the projector’s labels.

Attention - Refer to this User’s Guide for important safety information.

CAUTION: Hot Surfaces - Avoid touching hot surfaces. Do not touch until the projector has cooled.

Do Not Look Into The Lens!

Be extremely careful not to look into the projection lens when the projector is turned on. The bright light may harm your eyes. Be especially careful to keep children from looking into the lens.

Power Source

Use only a three-wire grounding type power source. The power source should not exceed 270 Volts RMS between the supply con- ductors or between either conductor and earth ground.

Power Cord

Use only the power cord that was shipped with the projector. Although other power cords might be similar in appearance, they have not been safety-tested with the projector. Do not use a power cord if it has become damaged or frayed. Contact Boxlight at 1-800-762-5757 if you need to replace your power cord.

iii

Image 7

Contents Page Trademarks Safety CertificationsFCC Warning DOC Canada EN 55022 WarningDeclaration of Conformity Page Table of Contents Appendix Maintenance and TroubleshootingIndex Do Not Look Into The Lens Safety SummaryPower Source Power CordHot Surfaces GroundingLamp Lamp CompartmentUnpacking the Projector Image ResolutionIntroduction CompatibilityT r o d u c t i o n Side view of projector Usage Guidelines WarrantyIf You Need Assistance Image Width Setting UP the ProjectorDistance to screen Diagonal Maximum MinimumT t i n g O j e c t o r Lowest image projection angle Upper lens Distance from lens center to lower edge of screen H DiagonalEquipment you want to connect Source Video Audio Projector has the following audio/video inputsAudio cable CablePro Lite cable Connecting the CablePro Lite computer cable to a Macintosh Connecting a Computer using BNC cables Connecting a Computer Using a Vesa cableConnecting a Video Player Connecting an External Speaker Connecting a Computer with an RS-232 Cable Connecting the Remote Control CablePowering up the Projector and Adjusting the Image Turning Off the Projector Page Basic Image Adjustment Using the ProjectorAdjusting the Projector Using the Remote Control Using the Remote and Keypad Buttons Light Computer 1, 2Freeze HelpScribble PowerVideo 1 Volume Using the On-Screen MenusOn-screen menu status bar Tint Display Menu FunctionsBrightness ContrastColor Color TemperatureReset All Blank ScreenBalance Audio Menu FunctionsTreble FadeBass Auto Image Image Menu FunctionsAuto Resize Vert. Position Manual SyncManual Tracking Horiz. PositionVideo Standard Controls Menu FunctionsStandby TIme Rear Projection Default SourceLanguage CeilingCleaning the Lens Maintenance and TroubleshootingCleaning the Fan Intake Filter I n t e n a n c e Troubleshooting Replacing the Projection Lamp Removing the lamp module Using the Kensington Lock Replacing the Batteries in the Remote ControlProblem The screen resolution is not right Problem Color or text not being projectedProblem Image isn’t centered on the screen Problem Image is too wide or narrow for screen Problem Only the start-up screen displaysProblem No sound Problem Image is out of focusProblem Image and menus are reversed left to right Problem Image and menus are upside downProblem Lamp shuts off Problem Lamp seems to be getting dimmerProblem Remote not operating correctly I n t e n a n c e Troubleshooting Appendix SpecificationsAudio Output Audio InputStandard Accessories ship with the projector AccessoriesOptional Accessories Executive Remote Control Executive Remote IR Receiver Key command to Computer Activate port De-activate port Portable and Laptop Activation ChartFN-F8 CRT/LCD FN-D NCR FN-F6 Using SimulScan Using Video Mirroring with a PowerBook ComputerDiagonal Distance to screen Projected Image Size for Optional LensesImage Width Long Throw Short Throw RS-232 Connection Pin AssignmentsWired remote Command format RS232 Terminal SpecificationsCommunication configuration Setting ValueSupported commands Function Command Range Function Command ResponseRST Page Index D e Page D e Limited Warranty Part Number