Tripp Lite BP240V10RT-3U owner manual Connection, Battery Module Feature Description

Page 10

Features (Rear Panel) continued

23.Input Voltage Select Switch (6kVA and 10kVA models only): Use this switch to set the transformer module's input voltage (either 200V AC, 208V AC or 240V AC). See “Connection” section for details.

24.AC Output Receptacles (5kVA models only): Accepts direct plug-in connection of NEMA 5-15P or NEMA 5-20P equipment plugs.

25.AC Output Breakers (5kVA models only): Push-button breakers control output power to transformer module's AC Output Receptacles which are directly adjacent.

26.Cable for Power Module Connection (5kVA models only): Plugs directly into either of the 5kVA power module's AC Output 2

Receptacles. NOTE: this cable should only be plugged into the 5kVA power module.

Battery Module Feature Description

27.Input Connector (select Battery Modules only): Use this connector to daisy chain additional battery modules onto the first. Remove the cover panel for access. Refer to the battery module owner’s manual for connection instructions and safety warnings.

28.Output Cable: Use this cable to connect the battery module to the power module or to another battery module. The power module will not start without a connection to a charged battery module. Refer to the battery module owner’s manual for connection instructions and safety warnings.

Connection

Hardwiring Cautions (6kVA & 10kVA models only)

•Wiring must be done by a qualified electrician.

•The UPS power module may be installed on its own or connected to an isolation transformer module. Both applications require the power module to be connected to a battery module.

•When making wiring connections, observe the cable connection regulations appropriate to your area [e.g. National Electrical Code (NEC) in the U.S.] at all times. Be sure to install an easily accessible disconnect switch in your installation wiring so you may cut off the UPS’s AC input during fires and other emergencies. Ensure that cables are fitted with cable sleeves and are secured by connector clamps. Tighten connections with a torque of not less than 24-28 inch-pounds (2.7-3.2 NM).

•Make sure that your equipment is properly grounded.

•Using cables of improper size may damage your equipment and cause fire hazards. Choose appropriate cabling and protection circuits to make wiring connections (Ground conductors must be the same size and type as the power conductors used):

 

RATED INPUT CURRENT

RATED OUTPUT CURRENT

RATED OUTPUT CURRENT

OUTPUT PROTECTION

 

200 - 240 (1Ø, 2-Wire + PE)

200 - 240V (1Ø, 2-Wire + PE)

120V (1Ø, 2-Wire + PE)

CIRCUIT

6kVA Models

30A 8 AWG (10mm2)

30A 8 AWG (10mm2)

2 × 30A 8 AWG (10mm2)

30A

10kVA Models

50A 6 AWG (16mm2)

50A 6 AWG (16mm2)

2 × 50A 6 AWG (16mm2)

63A

Connecting Modules to Each Other and to Utility Power and Equipment

There are three separate UPS system modules available from Tripp Lite (a power module and a battery module, which are required in all applications, and a transformer module) used in a variety of combinations. Follow the connection procedure below which matches the com- bination of modules which you plan on installing.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents SmartOnline Single-Phase 5kVA, 6kVA & 10kVA Important Safety Warnings Post Mounting Mounting RackPost Telecom Mounting Mounting Tower Features Power Module Front Panel ControlsFeatures Rear Panel see page 9 for feature descriptions 6kVA Power Module 6kVA Transformer Module 6kVA Battery ModuleFeatures Rear Panel see page 9 for feature descriptions Features Rear Panel Power Module Feature DescriptionBattery Module Feature Description ConnectionPlug the power module into a wall receptacle Plug your equipment into the power moduleConnect the battery module to the power module Plug the transformer module into the power module Hardwire the power module to your equipment Hardwire the power module to a utility power sourceHardwire the transformer module to your equipment Connect the power module to the transformer moduleHardwire the transformer module to a utility Power source Hardwire the power module to the transformer module Select the transformer module’s input voltage240V AC Optional Connection RS-232 Serial Communication ConnectionPower ON/OFF 5kVA models only Power ON/OFF 6kVA and 10kVA models only Only for power module maintenance or replacement Manual Bypass Operation 6kVA and 10kVA modelsStartup Self-Test OperationFailed Self-Test Normal Operation On Battery AlarmOverload Messages Bypass Messages Shutdown MessagesStorage ServiceYear Limited Warranty Regulatory Compliance Identification NumbersSpecifications SU6000RT3UXR SU10KRT3UHV* & SU10KRT3UManual del propietario Advertencias de seguridad importantes Montaje de 4 postes Montaje BastidorMontaje de 2 postes Telecomunicaciones Montaje en torre Características Controles del panel frontal del módulo de potenciaPage Módulo de potencia de 6 kVA Módulo de transformador de 6 kVA Módulo de batería para modelo de 6 kVACaracterísticas Panel posterior Descripción de características del módulo de potencia Características Panel continuaciónDescripción de características del módulo del transformador Conexión Descripción de características del módulo de bateríaConecte su equipo en el módulo de potencia Conecte el módulo de batería al módulo de potenciaConecte el módulo de transformador en el módulo de potencia Cablee el módulo de potencia a su equipo Conecte el módulo de potencia al módulo De transformador Cablee el módulo de transformador a su equipoSeleccione el voltaje de entrada del módulo De transformador Cablee el módulo de potencia al módulo de transformadorEntrada Interruptor de Interruptores/pantalla Conexión opcional Conexión de comunicación serie RS-232Encendido y apagado sólo en modelos de 5 kVA Encendido y apagado Sólo en modelos de 6 kVA y 10 kVA Page Auto-prueba de arranque OperaciónFallo durante la auto-prueba Operación normal Alarma On BatteryMensajes de sobrecarga Mensajes Bypass Mensajes de apagadoServicio Almacenamiento, Servicio y GarantíaAlmacenamiento Garantía limitada de 2 añosEspecificaciones SU6000RT3UXRManuel de lutilisateur Consignes de Sécurité Importantes Avertissements pour Connexion de lEquipementMontage à 4 supports Montage BaieMontage à 2 supports Telecom Montage Tour Commandes de Panneau Avant de Module dAlimentation Caractéristiques2524 Module Alimentation 6kVA Module Transformateur 6kVA Module Batterie pour Modèle 6kVAPage Caractéristiques Panneau Arrière suite Description des Caractéristiques de Module dAlimentationConnexion Description des Caractéristiques de Module de BatterieBranchez le module dalimentation dans une prise Murale Connexion suiteBranchez votre équipement dans le module Dalimentation Branchez le module à piles au module dalimentationConnexion suite Câbler le module dalimentation à votre équipement Câbler le module du transformateur à votre équipement Sélectionner la tension dentrée du module du transformateur Sélectionner la tension dentrée du module Du transformateur Connexion en Option Connexion Communication Série RS-232Alimentation en Marche/Arrêtée modèles 5kVA seulement Alimentation ON/OFF Modèles 6kVA et 10kVA seulement Opération Bypass Manuelle Modèles 6kVA et 10kVA seulement Autotest de Démarrage FonctionnementEchec de lAutotest Fonctionnement Normal Alarme Sur BatterieFonctionnement suite Messages de SurchargeMessages de Bypass Messages de FermetureEntretien Entreposage, Entretien, Garantie et AssuranceEntreposage Garantie Limitée à 2 AnsSpécifications Information sur le modèle Nos de modèleÈíñòðóêöèÿ âëàäåëüöà Âàæíàÿ èíñòðóêöèÿ ïî áåçîïàñíîñòè Óñòàíîâêà 4-êîíòàêòíîãî ñòåëëàæà Óñòàíîâêà ÑòåëëàæÓñòàíîâêà òåëåêîì íà 2õ îñíîâàõ Óñòàíîâêà Áàøíÿ Ñâîéñòâà Ïåðåäíÿÿ Ïàíåëü Áëîêà Ïèòàíèÿ6ÊÂÀ Áëîê Ïèòàíèÿ 6ÊÂÀ Ìîäóëü Èçîëèðóþùèé Òðàíñôîðìàòîð Ìîäóëü Áàòàðåè äëÿ ìîäåëåé 6ÊÂÀ è 10ÊÂÀ2120 Îïèñàíèå Ñâîéñòâ Áëîêà ïèòàíèÿ ìîäåëè 6ÊÂÀ è 10ÊÂÀ Ñâîéñòâà Çàäíÿÿ Ïàíåëü ïðîäîëæåíèåÎïèñàíèå Ñâîéñòâ Ìîäóëÿ Áàòàðåè 6ÊÂÀ è 10ÊÂÀ Ñîåäèíèòå áëîê ïèòàíèÿ ñ èñòî÷íèêîì ýëåêòðîýíåðãèè ÑîåäèíåíèåÑîåäèíèòå âàø ìîäóëü ïèòàíèÿ ñ îáîðóäîâàíèåì Ñîåäèíèòå ìîäóëü áàòàðåè ñ ìîäóëÿìè áëîêà ïèòàíèÿÑîåäèíèòå ìîäóëü òðàíñôîðìàòîðà ñ âàøèì Îáîðóäîâàíèåì Ñîåäèíåíèå ïðîäîëæåíèåÑîåäèíèòå ìîäóëü áëîêà ïèòàíèÿ ñ ìîäóëåì Òðàíñôîðìàòîðà Ñîåäèíèòå ìîäóëü òðàíñôîðìàòîðà ñ èñòî÷íèêîìÂûáåðèòå íàïðÿæåíèå ââîäà íà ìîäóëå òðàíñôîðìàòîðà Ñîåäèíèòå ìîäóëü áàòàðåè ñ ìîäóëåì òðàíñôîðìàòîðàÑîåäèíèòå âàø ìîäóëü òðàíñôîðìàòîðà ñ Îáîðóäîâàíèåì Äîïîëíèòåëüíîå ñîåäèíåíèå Ñâÿçü ÷åðåç Óíèâåðñàëüíûé Ñåðèéíûé Ïîðò USB RS-232ÂÊËÞ×ÈÒÜ/ÂÛÊËÞ×ÈÒÜ Page Ñàìîñòîÿòåëüíûé Ïðîâåðî÷íûé Òåñò Ñòàðòà Ïðàâèëà ÏîëüçîâàíèÿÑàìîñòîÿòåëüíûé ïðîâåðî÷íûé òåñò íå ïðîéäåí Çâóêîâîé Ñèãíàë Îò Áàòàðåè Ïðàâèëà Ïîëüçîâàíèÿ, ïðîäîëæåíèåÍîðìàëüíîå Ïîëüçîâàíèå Ñîîáùåíèÿ î ÏåðåãðóçêåÑîîáùåíèå î Ðåæèìå Ïåðåìû÷êè Ñîîáùåíèÿ ïî îòêëþ÷åíèþÑåðâèñ Ñåðâèñ/ÃàðàíòèÿÎãðàíè÷åííàÿ 2õ ëåòíÿÿ ãàðàíòèÿ Ñïåöèôèêàöèè SU6000RT3UXRTh Street Chicago, IL 60609 USA
Top Page Image Contents