Tripp Lite SU10KRT3, SU10KRT1X owner manual Battery Replacement Procedure

12 – Battery Replacement

DANGER! LETHAL HIGH VOLTAGE HAZARD!

All service, including battery replacement, should be performed by qualified service personnel, in accordance with the warnings in this manual and all applicable electrical and safety codes. Read, study and understand the warnings listed in “Section 2 – Important Safety Instructions” before proceeding.

Under normal conditions, the original batteries in the UPS system will last several years. The batteries are designed for hot-swap replacement (i.e. replacement while the UPS system is in ON mode), but some qualified service personnel may wish to put the UPS system in OFF mode and disconnect equipment as an extra precaution before proceeding.

Battery Replacement Procedure

(Follow steps 1-7 to remove old batteries, then reverse the procedure to add new batteries.)

1-3Remove Front Panel 4-5Remove Battery Compartment Cover 6-7Disconnect Old Batteries and Remove/Recycle Old Batteries 7-6Insert

New Batteries and Connect New Batteries (Attach battery connectors black-to-black and red-to-red.) 5-4Replace Battery Compartment Cover 3-1Replace Front Panel

1

2

3

4

5

6

7

20