Tripp Lite SU10KRT1X, SU10KRT3 Settings and Special Functions, Changing Default Settings

6 – Standard Operation continued

6-6 UPS System Settings and Measurements continued

Settings and Special Functions

After the UPS starts up completely, press to view settings and execute special functions. Scroll down to review the settings. Use the button to execute special functions. Special functions include buzzer ON Q1 or buzzer OFF Q2 and self-test OFF R1 or self-test ON R2 .

Q1 S2 V3

	Buzzer “ON”		Bypass Acceptance Range #2		Fixed 50 Hz Output
Q2		T		V4

	Buzzer “OFF”		Frequency Tolerance Window		Fixed 60 Hz Output
R1		U		W

	Self-Test “OFF”		Output Voltage Setting		Output Voltage Adjustment (±3%)
R2		V1		X

	Self-Test “ON”		UPS Normal Mode		UPS Identification Number
S1		V2		Y

Bypass Acceptance Range #1	UPS Economy Mode	Parallel Mode Enable/Disable
		(P 02 = Parallel Mode Enable)

Changing Default Settings

Make sure the UPS system is OFF Z . Press the “ON” button and “Next” button simultaneously for approximately three seconds until the buzzer sounds twice, then release the buttons. Except for buzzer Q1 / Q2 and self-test R1 / R2 , all other default settings may now be changed by pressing the “Previous/Change Setting” button. After changing settings, press the “Enter” button to save all changes AA. To cancel all changes, press and hold the OFFbutton for five seconds, then release the button BB.

Z AA BB

UPS Off Data Saved Settings Changes Canceled

15