Placement, Mounting Rack | Tripp Lite SU10KRT3, SU10KRT1X instruction

4 – Mounting continued

4-2 Placement

In order to minimize the possibility of damage to the UPS system and maximize its operational lifespan, follow the location warnings listed in Section 2 – Important Safety Instructions. Remember to keep at least 30 cm clearance from the rear panel of the UPS system to the wall and do not block any of the UPS system’s front or rear ventilation openings.

Warning: The UPS system is very heavy—be careful when moving or lifting it.

4-3 Mounting (Rack)

•Use the included rackmount shelves and mounting hardware to mount the UPS system in a 4-post rack or rack enclosure. To mount the UPS system in a 2-post (telecom) rack, order Tripp Lite’s 2-Post Rackmount Kit (model 2POSTRMKITWM, sold separately).

•The instructions in this manual are for common rack and rack enclosure types and may not be appropriate for all mounting applications. The user must determine the fitness of hardware and procedures before mounting. If hardware or procedures are not suitable for the application, contact the manufacturer of the rack or rack enclosure for a solution.

4-Post Mounting Procedure

Note: The mounting procedure is identical for the external battery pack and the UPS power module. Mount the external battery pack first, then repeat the procedure for the UPS power module. The external battery pack should be mounted in the lowest available rack space. The UPS power module should be mounted directly above the external battery pack.

1Adjust the depth of the mounting shelves B3 and B4 to fit the rack, then mount the shelves in the lowest available rack space. Insert cage nuts N1 through the smaller square holes of the shelves, then attach the shelves to the rack’s vertical mounting rails. (The shelves should face inward.) Use M5 flat-head screws S3 for the front and rear vertical rails; use washer plates B5 for the front vertical rails only. Tighten all screws before proceeding.

2Use M4 flat-head screws S2 to attach pulls B1 to the mounting brackets B2 .

3Use M3 flat-head screws S1 to attach the mounting brackets to the cabinet.

4With the aid of an assistant, lift the cabinet and place it on the mounting shelves. Insert M5 pan-head screws S4 through the mounting brackets and into the vertical mounting rails. Tighten all screws securely.

	N1
	B4
	N1
	B3
S3	B5
	S3
1

4	S4