Schneider Electric Powerlogic E4800 Configuration Tool Guide, Configuration and Programming

930-112-01	PowerLogicTM E4800 Series
02/2009	PowerLogic E4800 configuration tool guide

POWERLOGIC E4800 CONFIGURATION TOOL GUIDE

This document describes how to configure the the PowerLogic E4800 meter (PowerLogic E4833, E4880 and E4805 meters), using the PowerLogic configuration tool. It includes the following configuration tool information:

•“System Set-up and Description” on page 1

•“Configuration and Programming” on page 1

•“Display Navigation” on page 4

•“PowerLogic Configuration Tool” on page 7

•“Communications Connections” on page 5

•“Configuring the meter” on page 7

•“Manufacturing Tab” on page 16

•“Meter Points (Circuits) Tab” on page 17

•“Pulse Probes Tab” on page 20

•“Completing the Meter Configuration” on page 21

	This documentation is intended for those responsible for configuring the
	PowerLogic E4833, E4880 and E4805 meters.
System Set-up and Description	The configuration tool supports the PowerLogic E4833, E4880 and E4805
	meters.
	Depending on how the meters are installed and configured, they can meter
	8, 12, or 24 individual meter points. The PowerLogic E4833, E4880 and
	E4805 meters are designed for residential, commercial, and industrial use
	and display the power and consumption readings for each measurement
	point.
Configuration and Programming	The configuration tool is used to change any of the programmable
	parameters within the PowerLogic E4800 meters. The combination of the
	configuration tool and the state of the meter programming switches
	determine which parameters can be changed. As shown in Figure ?, the
	programming switches are two-position DIP switches labeled SW1, and are
	located inside the meter cover below the Display button. To enable meter
	configuration, both switches must be physically set to the ON (down) position
	(default).

© 2009 Schneider Electric All Rights Reserved 1