Network Technologies T15-RS16, 8 operation manual Connect to the Serimux, Saving and Exiting Setup

NTI RACK MOUNT CONSOLE TERMINAL WITH CONSOLE SWITCH

The following lists only what is necessary to connect to SERIMUX. For a complete list of features, see page 30.

F2- Genrl SETUP Menu

Personality set to Digital Equipment VT-100 or Console ANSI

F4- Comm SETUP Menu

Baud Rate set to 9600

Ethernet Mode set to OFF to set the communication routing by Serial Port.

Data / Stop Bits set to send and receive 8-bits data with one stop bit

Xmt Handshake set to None

Parity set to none

2.1.4 Saving and Exiting Setup

The first menu seen when entering Setup serves as a directory to the other Setup menus. To exit Setup or any submenu, press <F12>. Pressing <F12> will return the display to the main Setup directory and with another press of <F12> the user will exit

Setup.

The highlighted field at the right of the screen gives the user the choice of saving or not saving parameter changes into

memory before returning the TERMINAL to the normal operating mode. Settings changed will effect the operating environment until the TERMINAL is powered-down. Setting changes will only be restored at power-up if they are saved before exiting Setup.

NOTE: If settings are not saved before exiting Setup, any new selections will be lost when the RACKMUX is powered- down.

To save Setup selections, depress the Spacebar to change the save field at the right side of the screen from NO to YES before exiting Setup. (Table 1 describes your options for exiting Setup.)

Depress <F12> to leave Setup and return to the normal display mode.

Table 1- Main Setup Menu (F12) Exit Functions

Option	Function
No	Returns terminal to normal operating mode without saving parameters changes for power up
Yes	Saves all changes (operating parameter, tabs, key definition, and answerback message); returns terminal
	To its normal operating mode.
Shift + Esc	Restores all setting (operating parameters, tabs, key definitions, and answerback message) to their factory
	default values.

For changes to the TERMI”NAL settings to take effect, the RACKMUX must be power cycled. Disconnect power from the AC adapter and reconnect.

2.2 Connect to the SERIMUX

1.Press [ Enter ] on the keyboard to be recognized as the default SERIMUX user. The "Accessible host list" for "User01", logged in at "Port00" will be displayed (see Fig 6). By default, all ports are configured as Host ports and all are accessible.

NOTE: If the user menu does not display re-initialize the SERIMUX following the "Initialize SERIMUX Console Switch to default settings" instructions on page 30.

9