NTI RACK MOUNT CONSOLE TERMINAL WITH CONSOLE SWITCH
¾Verbose mode
Send or type in:
[V][Enter] The answer will be:
OK [CR][LF]
and the Terse mode will be terminated. The “Accessible host list” or the “User main menu” will be displayed.
Note: Once a user configured for Terse mode login exits Terse mode to enter Verbose mode, Terse mode login will no longer be available at login. To return to Terse mode, the administrator must
¾User Logout
Send or type in:
[L][Enter] The answer will be:
OK [CR][LF]
With the next login of the same user, Terse mode will resume.
FYI: Buttons pressed in sequence on the keypad to enter commands must be pressed within 5 seconds of each other for the SERIMUX to respond. Otherwise, the sequence will need to be repeated from the beginning.
¾Login the administrator
Note: In order to login the administrator to a port other than port 0, the administrator must first configure the desired port as a user port (see page 15). By default, all ports, other than 0, are configured as host ports.
3.2.5 Initialize SERIMUX Console Switch to default settings
SERIMUX can be reset to default settings by using the "RESET" button
The RACKMUX should be OFF before pressing the "RESET" button.
1.Press and hold the "RESET" button using a small object that will fit through the hole in the back of the SERIMUX. (See Fig. 21).
2.Turn ON the RACKMUX.
3.Wait 3 seconds.
4.Release the button.
Rear View of RACKMUX
ETHERNETPARALLELSERIAL
Factory reset button
12VDC |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
- 5A | + | NTI | 16 | 15 | 14 | 13 |
| 12 | 11 | 10 | 9 |
| 8 | 7 | 6 | 5 |
| 4 | 3 | 2 | 1 | |
|
| R NETWORK |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
| TECHNOLOGIES |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
| INCORPORATED |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
| 1275 Danner Dr |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
| Aurora, OH 44202 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
| www.networktechinc.com |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Figure 24- Location of RESET button
Caution: During initialization, the customer modified parameter values will be replaced with the factory default values (for default values, see Table 2, page 31), user names and passwords will be erased.
30