Setting Description Value | Network Technologies T15-RS16, 8

NTI RACK MOUNT CONSOLE TERMINAL WITH CONSOLE SWITCH

From the Port settings menu, the configuration of each port can be viewed and changed.

Setting	Description	Value
Port name	Change the port name	Max. 15 characters
Port type	Host or User	H	or U
In-band disconnect	Select characters to use for in-	1 + code for 1-character sequence (see Fig. 6 below)
sequence	band disconnect sequence	3 + desired characters for 3-character sequence
		0- for no disconnect sequence
		T-	display Control code list
Connection	Time left before connection will be	0-90 minutes. If 0 is selected, the connection will
Timeout	broken due to receiver inactivity	never timeout.
Serial settings	Display serial settings menu	N/a
Modem settings	Display modem settings menu	N/a
View port data	View the last 1016 characters	N/a
buffer	received and transmitted to/from
	the port
VT100 displaying	Modify the displaying extra delay	0 = None,1 = normal, 2 = double, or 3 = triple
delay		"None" value can be used if the display is faster (i.e. with a

		terminal emulator, like HyperTerminal, running on a PC); the
		other values are useful if real terminals or slower serial
		devices are used as user/administrator consoles.
Reset Port settings	Restores factory default port	A confirmation "Y" will be required
to default	settings

When [3] is pressed to change the in-band disconnect sequence, the choices provided are 0, 1, 3, or T. Pressing a [T] will bring up a Control code list containing key sequences used for 1-character sequences, and the ASCII codes associated with each. (See Fig 6) To set a 1-character sequence, press [1], then the code from the table associated with the desired sequence.

Note: If the 3-character disconnect sequence is enabled, the string: [CR][LF]<3-char sequence>[CR][LF] has to be received to break the connection (7 characters). The [CR] and [LF] ASCII characters stand for 13 and 10 decimal codes (ASCII Carriage Return and Line Feed) respectively.

FYI: If the 1-character sequence is selected, the connected device will not receive the disconnect character. If the 3-character sequence is selected, it will be sent to the connected device, prior to breaking the connection.

Figure 10- Control Codes for in-band disconnect sequence

-	When selecting each new port setting values, press [Esc] or [Spacebar] to cancel, or press [Enter] to save.

-Press [>] (greater than symbol) to display the current settings for the next port.

-Press [<] (less than symbol) to display the current settings for the previous port

-Press [Esc] or [Spacebar] to return to the "Administrator main menu"