Sun Microsystems X2100 M2 Powering On and Powering Off Server, Back Panel Label Connector/Slot

Page 10

1

2

3

4

5

6

7

8

10 9

FIGURE 1-2 Back Panel

TABLE 1-1 Back Panel

Label

Connector/Slot

Label

Connector/Slot

 

 

 

 

 

1

Power connector

6

NVIDIA Ethernet connectors (LAN-2 left,

 

 

 

 

LAN-3 right)

2

Broadcom Ethernet connectors (LAN-0 top,

7

Serial management/DB9 RS-232 serial port

 

LAN-1 NET MGT bottom)

 

 

3

System identification button/LED

8

PCI-Express slots

4

Fault LED

9

Onboard HD15 video connector

5

Power LED

10

USB 2.0 connectors (4)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Powering On and Powering Off the

Server

You only need to apply standby power to the server at this point so that you can

perform initial configuration of the service processor. Procedures for powering on to main power mode and for shutting down from main power mode are also included in this section.

6 Sun Fire X2100 M2 Server Installation Guide • August 2006

Image 10
Contents Sun Fire X2100 M2 Server Installation Guide Please Recycle Contents Configuring the Preinstalled Solaris 10 Operating System Setting Up the Sun Fire X2100 M2 Server Hardware Safety and Compliance InformationPlanning the Installation Process StartPackage Contents Inventory Installing the Server Into a Rack With Optional Slide Rails Connecting the Cables To Connect the CablesPowering On and Powering Off Server Back Panel Label Connector/SlotConfiguration Without adequate cooling mechanisms To Power On Main Power Mode To Power Off Main Power ModeSetup Troubleshooting and Support Troubleshooting the Sun Fire X2100 M2 Server Setup3Troubleshooting Procedures Contacting Support 4System Information Needed for SupportSun Fire X2100 M2 Server Documentation Setting Up the Sun Fire X2100 M2 Server Software About the Embedded LOM Service Processor SoftwareSun Fire X2100 M2 Server Installation Guide August To Configure the Embedded LOM SP Using a Serial Connection Show /SP/AgentInfo Configuring the Embedded LOM SP Using an Ethernet Connection To Configure the Embedded LOM SP Using a Dhcp ServerLog in to your Dhcp server and view its Dhcp log file # ssh -l root To Configure the Embedded LOM SP Using a Static IP Address To Configure Static IP Addresses Using the Web GUIClick the Control button to display the drop-down menu Network Settings Page displays To Configure Static IP Addresses Using the CLI Changing Serial Output to Display the System Information1Serial Terminal Key Remapping Configuring or Installing System Software Additional Preinstalled Software Installing Other Operating Systems and DriversInstallation Worksheet Before You BeginInstallation Worksheet Configuring the Preinstalled Solaris 10 Operating System Installation Worksheet Configuring the Preinstalled Solaris 10 Operating System To Connect to the Server Using a Serial Capture Program onSelect Advanced To Connect to the Server Using a Serial Capture Program To Redirect the Console Output to the Video Port OptionalStart a terminal session to capture the serial port output Downloading Solaris 10 OS Software Accessing Solaris 10 User DocumentationSolaris 10 Operating System User Information Solaris 10 OS TrainingSun Fire X2100 M2 Server Installation Guide August