Sun Microsystems X2100 M2 manual Configuring or Installing System Software

Page 29

TABLE 2-1Serial Terminal Key Remapping (Continued)

Key	ANSI Escape Sequence	Windows Equivalent

Insert	Esc+Shift-[+Shift--2	Esc++
Delete	Esc+Shift-[+Shift--3	Esc+-
Page Up	Esc+Shift-[+Shift--5	Esc+?
Page Down	Esc+[+6	Esc+/
Up Arrow	Esc+[+Shift-a	Esc+w
Down Arrow	Esc+[+Shift-b	Esc+x
Right Arrow	Esc+[+Shift-c	Esc+d
Left Arrow	Esc+[+Shift-d	Esc+a
Reset	no equivalent	Esc+R+Esc+r+Esc+R

Configuring or Installing System Software

If your server has at least one hard drive installed, the server might have the Solaris™ 10 Operating System and additional software preinstalled.

■To configure the preinstalled Solaris 10 Operating System on your server, see Chapter 3.

■For information on additional preinstalled software, see “Additional Preinstalled Software” on page 26.

■If you plan to install a different operating system see “Installing Other Operating Systems and Drivers” on page 26.

Chapter 2 Setting Up the Sun Fire X2100 M2 Server Software 25

Image 29

Contents Sun Fire X2100 M2 Server Installation Guide Please Recycle Contents Configuring the Preinstalled Solaris 10 Operating System Safety and Compliance Information Setting Up the Sun Fire X2100 M2 Server HardwareStart Planning the Installation ProcessPackage Contents Inventory Installing the Server Into a Rack With Optional Slide Rails To Connect the Cables Connecting the CablesBack Panel Label Connector/Slot Powering On and Powering Off ServerConfiguration Without adequate cooling mechanisms To Power Off Main Power Mode To Power On Main Power ModeTroubleshooting the Sun Fire X2100 M2 Server Setup Setup Troubleshooting and Support3Troubleshooting Procedures 4System Information Needed for Support Contacting SupportSun Fire X2100 M2 Server Documentation About the Embedded LOM Service Processor Software Setting Up the Sun Fire X2100 M2 Server SoftwareSun Fire X2100 M2 Server Installation Guide August To Configure the Embedded LOM SP Using a Serial Connection Show /SP/AgentInfo To Configure the Embedded LOM SP Using a Dhcp Server Configuring the Embedded LOM SP Using an Ethernet ConnectionLog in to your Dhcp server and view its Dhcp log file # ssh -l root To Configure Static IP Addresses Using the Web GUI To Configure the Embedded LOM SP Using a Static IP AddressClick the Control button to display the drop-down menu Network Settings Page displays Changing Serial Output to Display the System Information To Configure Static IP Addresses Using the CLI1Serial Terminal Key Remapping Configuring or Installing System Software Installing Other Operating Systems and Drivers Additional Preinstalled SoftwareBefore You Begin Installation WorksheetInstallation Worksheet Configuring the Preinstalled Solaris 10 Operating System Installation Worksheet To Connect to the Server Using a Serial Capture Program on Configuring the Preinstalled Solaris 10 Operating SystemSelect Advanced To Redirect the Console Output to the Video Port Optional To Connect to the Server Using a Serial Capture ProgramStart a terminal session to capture the serial port output Solaris 10 Operating System User Information Accessing Solaris 10 User DocumentationDownloading Solaris 10 OS Software Solaris 10 OS TrainingSun Fire X2100 M2 Server Installation Guide August