Sun Microsystems X2100 M2 manual Configuration Without adequate cooling mechanisms

▼To Apply Standby Power for Initial Service Processor Configuration

Use this procedure to apply standby power to the service processor (SP) before initial

configuration.

Caution – Do not operate the server without all fans, component heatsinks, air baffles, and the cover installed. Severe damage to server components can occur if operated

without adequate cooling mechanisms.

1.Connect a grounded AC power cord to the AC power connector on the back panel of the server and to a grounded AC power outlet.

In standby power mode, the Power/OK LED on the front panel flashes, indicating that the SP is working. See FIGURE 1-3and TABLE 1-2.

1 2 3 4 5 6 7 8

FIGURE 1-3 Front Panel

TABLE 1-2	Front Panel
Label	Button/LED/Port	Label	Button/LED/port
1	System identification button/LED	5	Optional hard disk drive 0
2	Fault LED	6	USB 2.0 connectors (2)
3	Power/OK LED	7	Optional DVD drive
4	Power button	8	Optional hard disk drive 1

2.Continue with initial software setup tasks, as described in Chapter 2.

Note – At this point, standby power is supplied only to the service processor and power supply fans. You can proceed to Chapter 2 of this guide to begin initial configuration. Do not apply main power to the rest of the server until you are ready to install a platform operating system.

Chapter 1 Setting Up the Sun Fire X2100 M2 Server Hardware 7