Sun Microsystems X6270 manual Cpu

TABLE 2-1Filler Panel Replacement Procedures (Continued)

Filler Panel Module	Remove Procedure		Install Procedure
Storage Drive	1.	Locate the disk drive filler panel to be	1.	Locate the vacant disk drive module slot in the
Module*		removed from the server.		server, then ensure that the release lever on the
	2.	To unlatch the disk drive filler panel,		filler panel is fully opened.
*Hard disk drive		press the release lever button then tilt	2.	Slide the filler panel into the vacant slot by
or solid state		the lever up into the fully opened		pressing the middle of the filler panel faceplate
drive		position.		with your thumb or finger.
	3.	To remove the filler panel from the		The release lever will rise as it makes contact
		slot, hold the opened release lever and		with the chassis. Do not slide the filler panel in
		gently slide the filler panel toward		all the way. Leave the filler panel out
		you.		approximately 0.25 to 0.50 inch (6 to 12 mm)
				from the opening.
			3.	Using your thumb or finger, press on the
				middle of the filler panel faceplate until the
				release lever engages with the chassis.
			4.	Close the release lever until it clicks into place
				and is flush with the front of the server.
CPU	1.	Use an Allen wrench (4mm) to loosen	1.	Lower the air baffle over the CPU socket, and
Air Baffle		the two mounting screws.		align the holes for the mounting screws on the
(over empty	2.	Gently pull up the air baffle to expose		motherboard.
CPU socket)		the empty CPU socket.	2.	Insert the two mounting screws, then use an
				Allen wrench (4mm) to tighten the screws.

Note – For instructions for adding or replacing chassis component filler panels (for example, network modules or chassis monitoring modules), consult the documentation supplied with your chassis.

Chapter 2 Install Server Module Optional Components 13