Sun Microsystems X6270 manual Add a Drive, 12Add Drive Server Not Installed in Chassis

▼Add a Drive

1.Locate and remove the drive filler panels from the server module bays.

For drive locations on the server, see “Sun Blade X6270 Server Module Option Locations” on page 8.

For instructions to remove drive filler panels, see “Remove or Insert Filler Panels” on page 12.

2.Ensure that the release lever on the drive is in a fully opened position.

3.Slide the drive into the vacant slot by pressing the middle of the drive faceplate with your thumb or finger.

The release lever will rise as it makes contact with the chassis.

Do not slide the drive in all the way. Leave the drive out approximately 0.25 to 0.50 inch (6 to 12 mm) from the opening.

For example:

■If adding a drive to a server module and the server module has not been installed in the system chassis, see FIGURE 2-12.

or

■If adding a drive to a server module and the server module is installed in the system chassis, see FIGURE 2-13.

FIGURE 2-12Add Drive - Server Not Installed in Chassis.

Chapter 2 Install Server Module Optional Components 29