Sun Microsystems X6270 manual Logging In to Ilom, Log In to Ilom Using a Serial Connection

TABLE 4-1IP Address Configuration Tasks (Continued)

Step Requirement Description

4Log in to ILOM. Follow instructions in this chapter to log in to ILOM. See “Logging In to ILOM” on page 47.

5	Configure an IP	Follow the instructions in this chapter to initially configure an
	address.	IP address: see “Configuring an IP Address” on page 49.
6	If applicable,	For more information about configuring or modifying an IP
	obtain	address in ILOM, refer to the Sun Integrated Lights Out Manager
	additional	2.0 User’s Guide or the Integrated Lights Out Manager 3.0
	information	Documentation Collection.
	about ILOM.

Logging In to ILOM

This section presents the following procedures:

■“Log In to ILOM Using a Serial Connection” on page 47

■“Log In to ILOM From an Ethernet Connection Using the CLI” on page 48

▼Log In to ILOM Using a Serial Connection

1.Verify that your serial console connection to the server module or CMM is secure and operational.

2.Ensure that the following serial communication settings are configured.

■8N1: eight data bits, no parity, one stop bit

■9600 baud (default, can be set to any standard rate up to 57600)

■Disable hardware flow control (CTS/RTS)

3.Press Enter to establish a connection between your serial console and ILOM. A login prompt to ILOM appears.

Chapter 4 Setting Up ILOM 47