METRObility Optical Systems RADIANCE 10/100MBPS ACCESS OPTICAL NETWORK UNIT manual Data Rate

Page 20

Technical Specifications

Data Rate

Data Rate ________ 100Mbps half duplex, 200Mbps full duplex (Fast Ethernet)

______________ 10Mbps half duplex, 20Mbps full duplex (Ethernet)

Network Connections

Twisted-Pair Interface

Connector __________________________________ Shielded RJ-45, 8-pin jack

Impedance ________________________________________ 100 Ohms nominal

Signal Level Output (peak differential) ______________ 2.2 to 2.8 V (10Mbps)

___________ 0.95 to 1.05 V (100Mbps)

Signal Level Input _________________________ 585 mV minimum (10Mbps)

________________________ 200 mV minimum (100Mbps)

Supported Link Length _________________________________________ 100m

Cable Type _______________________ Category 3, 4 or 5 UTP/STP (10Mbps)

_______________________ Category 5 or 5E UTP/STP (100Mbps)

Multimode F/O Interface (RA21-13, RA21-15)

Connector ________________________________________________ ST or SC

Wavelength _______________________________________________ 1310 nm

RX Input Sensitivity ________________________________ -31 dBm minimum

Output Power ________________________ -23.5 dBm to -14 dBm (50/125m)

________________________ -20 dBm to -14 dBm (62.5/125m)

Supported Link Length ___________________________ up to 2 km full duplex

Cable Type ________________________________ 50/125 or 62.5/125 m F/O

Singlemode F/O Interface (RA21-14, RA21-16)

Connector ________________________________________________ ST or SC

Wavelength _______________________________________________ 1310 nm

RX Input Sensitivity ________________________________ -29 dBm minimum

Output Power ____________________________________ -15 dBm to -8 dBm

Supported Link Length __________________________ up to 20 km full duplex

Cable Type ___________________________________________ 9/125 m F/O

Singlemode F/O Interface — long haul distance support (RA21-17)

Connector _____________________________________________________ SC

Wavelength _______________________________________________ 1310 nm

RX Input Sensitivity ________________________________ -34 dBm minimum

Output Power ______________________________________ -5 dBm to 0 dBm

Supported Link Length __________________________ up to 40 km full duplex

Cable Type _______________________________________ 9/125 m SM F/O

20 User Guide

Image 20
Contents Installation & User Guide Radiance Access Optical Network Unit 10/100Mbps Copper to FiberInstallation & User Guide Overview Radiance 10/100Mbps Access Optical Network Unit 1Unpack the Unit 2Set the SwitchesMDI-IIto MDI-XSwitch twisted-pair port only Default Settings Duplex Link Loss Carry Forward 3Connect to the NetworkTwisted-Pair Interface 4Apply Power Installation Guide Default Hardware Switch Settings LED IndicatorsFactory Settings Default Software Settings Software SettingsLoopback Mode Port Enable/DisableEthernet Statistics Remote Management StatisticsRmon Statistics Singlemode Fiber Optic Power Monitors Input Power LevelLink Loss Carry Forward Llcf Link Loss Return LLR Topology Solutions Network Connections Technical SpecificationsData Rate Power EnvironmentalProduct Safety, EMC and Compliance Statements CSAWarranty and Servicing Product Manuals