Paradyne BitStorm 2600 manual Unpacking the Hardware, Package Contents

Page 14

1. Installation

Unpacking the Hardware

HANDLING PRECAUTIONS FOR

!STATIC-SENSITIVE DEVICES

This product is designed to protect sensitive components from damage due to electrostatic discharge (ESD) during normal operation. When performing installation procedures, however, take proper static control precautions to prevent damage to equipment. If you are not sure of the proper static control precautions, contact your nearest sales or service representative.

The BitStorm 2600 is shipped in a cardboard shipping container. Carefully remove the unit from its shipping container and check for physical damage. If the unit shows signs of shipping damage, notify your sales representative.

Package Contents

In addition to this installation guide, the BitStorm 2600 shipping carton should contain:

„BitStorm 2600 DSLAM

„AC Power Cable

„Two sets of mounting brackets: one set suitable for a 19-inch (483 mm) rack and one set suitable for a 23-inch (584 mm) rack (including Bay Networks and Nortel)

„Hardware kit (see Table 1-2, Contents of Hardware Kit Shipped with the BitStorm 2600)

If anything is missing, notify your sales representative.

Before installing the BitStorm 2600, read the Important Safety Instructions in the beginning of this document.

Be sure to register your warranty at www.paradyne.com/warranty.

1-4

March 2005

2600-A2-GN20-40

Image 14
Contents IP Dslam Copyright 2005 Paradyne Corporation All rights reserved Software and Firmware License Agreement Important Safety Instructions United States EMI Notice Japan Contents Equipment List Technical Specifications Index ConfigurationConnectors and Pin Assignments LEDsDocument Summary About This GuideDocument Purpose and Intended Audience Related Product Documents Document Number Document TitleInstallation Overview„ Installation Site PreparationCables Required DSL PortsPackage Contents Unpacking the HardwareFlat-head screw for attaching 19 mounting brackets to Mounting Brackets Mounting ConfigurationsInstalling the Brackets for Rack Mounting Inch 483 mm Rack Mount Installing the BitStorm 2600 Into a Rack 03-17436 Installing the BitStorm 2600 on a Wall 17.85 in 453 mm Installing the BitStorm 2600 on a Shelf or Desktop Cabling Cabling OverviewDSL Ports GigE Uplink Port 10/100BaseT Uplink Port T1 or E1 Uplink Chaining BitStorm 2600s Management Port Connecting a Terminal or PC to the Console Port Console PortConnecting a Modem to the Console Port Alarm Interface Ground Connecting to Power LEDs LED LocationsLED Meanings LEDConfiguration Using the CLI CLI Commands FunctionConfigure Management Inband Address BitStorm 2600 Startup Procedure LoginStartup Procedure for Inband Management Startup Procedure for Out-of-Band ManagementUsing the Web Interface System / Users Configuration / Management / Snmp Connectors and Pin Assignments Figure A-1. BitStorm 2600 IP Front PanelDSL Ports and Pots Splitter Connectors Port 1 and Port 2 10/100BaseT Connectors Port 3 1000BaseT ConnectorPort 3 GigE SFP Connector Table A-4. Port 3 GigE Connector Signal PinE1 and T1 Uplink Connectors Console Port ConnectorAlarm Connector Table A-7. Alarm Connections Signal Direction ContactEquipment List DSLTable B-1. BitStorm 2600 Model List 2 Technical Specifications DSLTable C-1. BitStorm 2600 Technical Specifications 2 Criteria Index NumericsIN-2 IN-3 IN-4