Paradyne manual BitStorm 2600 Startup Procedure, Login

4. Configuration

BitStorm 2600 Startup Procedure

You can initialize your BitStorm 2600 via a PC or terminal connected to the unit’s CONSOLE port. Then, using a series of CLI commands, GrandVIEW EMS or another Element Management System, or the web interface, you can configure the unit according to your requirements.

Login

Procedure

To log in to the BitStorm 2600:

1.Connect a PC or terminal to the CONSOLE port. (See Console Port in Chapter 2, Cabling.)

2.At the login> prompt, type admin and press Enter.

3.At the password> prompt, press Enter. The default login password is blank.

4.At the PDYN> prompt, type privilege and press Enter.

5.At the password# prompt, press Enter. The default privileged password is blank.

You are now logged on and in privileged mode, which allows you to configure the unit.

Management Modes

The startup procedure for the BitStorm 2600 system differs depending on the type of management used:

„Inband Management – Operates over the uplink.

„Out-of-Band Management – Operates over Port 1.

4-4 March 2005 2600-A2-GN20-40