Polycom RMX 2000 Hardware Guide
3Use the metal ejector levers to pull the CNTL Module out of its slot in the Backplane.
4Carefully slide the CNTL Module out through the front panel.
5On the CNTL Module to be installed, move the ejector lever to the fully open position.
6Slide in the replacement CNTL Module.
7Push the CNTL Module firmly into the Backplane, making sure it is properly seated in its slot.
8Ensure that the metal ejector levers are fully retracted into their housings.
9Tighten the captive screws on the front panel of the RMX 2000 that secure the Functional CNTL Module.
10Turn ON the RMX 2000.
For more information on the Card Configuration Modes after reset, see "MPM and MPM+ Configuration Modes” on page