Polycom 1725-36060-001 manual Subnet roaming configuration between multiple MX switches

Page 10

Configuration Guide

Subnet roaming configuration between multiple MX switches

To set up subnet roaming between two switches, a mobility domain must be configured on both switches. Choose one of the switches to be the “seed” switch.

The IP addresses used in mobility domain configuration must use the system IP address of each switch).

The following commands are performed on the seed MX switch:

set system ip-address 1.1.1.1

set mobility-domain mode seed domain-name <domain name> set mobility-domain member 1.1.3.1

# configures the domain member

The following commands are performed on the other (member) MX switch:

set system ip-address 1.1.3.1

set mobility-domain mode member seed-ip 1.1.1.1

Be sure to disable IGMP snooping temporarily on the MX that does

NOT have the VLAN statically configured by using the command:

set igmp disable vlan v1

#the VLAN name must be specified after the vlan keyword

If you have a previous mobility-domain configuration that is no longer valid, you must clear the existing mobility-domain before a new one can be defined:

clear mobility-domain

#system will respond: Success: change accepted show mobility-domain config

#system will respond: There is no mobility domain configuration

To check the mobility domain, use the following command:

show mobility-domain

The system will respond:

Mobility Domain name: default

Member State

1.1.1.1STATE_UP SEED

1.1.3.1

STATE_UP

MEMBER

10

PN: 1725-36060-001_D.doc

Image 10
Contents Trapeze Networks Trademark Information Introduction Certified Product SummaryService Information Network Topology Access Point Setup and Configuration Installing softwareService profile commands Ssid & security policy setup WPA2-PSKRadio profile commands Network topology and MP access point hardware configurationRadio configuration SVP configurationSubnet roaming configuration between multiple MX switches Following commands are performed on the seed MX switchChecking the configuration Configuration File For Reference Only Trapeze Networks Mobility System for MP 422 Access Points Set radio-profile RealRadio auto-tune power-backoff Trapeze Networks Mobility System for MP 422 Access Points Configuration Guide