TP-Link manual Hardware Connection - Internet, TL-PA210 AV200 Nano Powerline Adapter

Page 13

2.6 Hardware Connection – Internet

TL-PA210AV200 Nano Powerline Adapter

2.6 Hardware Connection – Internet

This section describes how to connect the Powerline Adapter into your existing ADSL broadband connection via ADSL Ethernet port. Follow the procedures described below to connect the Powerline Adapter to your ADSL broadband connection:

1．Connect one end of the provided Ethernet (RJ45) cable to the Powerline Adapter’s Ethernet port.

2．Connect the other end of the Ethernet (RJ45) cable to an available Ethernet port of your ADSL broadband Router.

3．Plug the Powerline Adapter into a wall socket next to the computer.

4．Turn on your computer.

5．Check and confirm that the Power LED, Ethernet LED, and Powerline LED on the Powerline Adapter are ON.

The hardware connection mechanism is shown below:

7

Image 13

Contents REV3.0.1 TL-PA210 AV200 Nano Powerline AdapterCOPYRIGHT & TRADEMARKS CE Mark Warning FCC STATEMENTSafety Information EN EN EN 61000-3-22006+A12009+A22009 EN EN Product Description AV200 Nano Powerline AdapterEN60950-12006+A112009+A12010+A122011 Yang Hongliang Product Manager of International BusinessChapter 5 Advanced Feature How to Use the Pair Buttons CONTENTSTL-PA210 AV200 Nano Powerline Adapter Package ContentsChapter 1 Introduction 1.3 Important Safety Instructions1.1 Conventions 1.2 System Requirement¾ If liquid has been spilled on the product 2.2 LED Indicator Chapter 2 Connecting Mechanism2.1 Introduction StatusTL-PA210 2.3 Physical InterfaceInterface Description2.5 Hardware Connection - Computer 2.4 Connection Instruction2.6 Hardware Connection - Internet TL-PA210 AV200 Nano Powerline Adapter Chapter 3 Installing Management Utility TL-PA210 AV200 Nano Powerline Adapter TL-PA210 AV200 Nano Powerline Adapter TL-PA210 AV200 Nano Powerline Adapter 4.1 Status Chapter 4 Using the Management Utility4.1.1 Set Local Device’s Network Name 4.2 Network4.2.1 Rename the Remote Device/Enter Password 4.2.2 Add Device Password is unnecessary to enter for renaming4.3 System 4.3.1 Upgrade Firmware4.3.2 Reset Device To upgrade the devices firmware, follow these instructions4.3.3 Set All Devices’ Network Name 5.2 Set Up a Powerline AV Network with the Pair Button Chapter 5 Advanced Feature How to Use the Pair ButtonsCreate a Powerline network using the Pair button： 5.1 Pair Secure with 128 bits-AESLeave an existing Powerline AV Network Join an existing Powerline AV NetworkThe sequence of Step 1 and Step 2 can be exchanged 1. The Power LED does not light up. Ans. Check the following Appendix A Troubleshooting3. The Powerline LED does not light up 2. The Ethernet LED does not light up