TP-Link TL-PA210 manual Safety Information

Page 4

Safety Information

•When product has power button, the power button is one of the way to shut off the product; when there is no power button, the only way to completely shut off power is to disconnect the product or the power adapter from the power source.

•Don’t disassemble the product, or make repairs yourself. You run the risk of electric shock and voiding the limited warranty. If you need service, please contact us.

•Avoid water and wet locations.

Image 4

Contents TL-PA210 AV200 Nano Powerline Adapter REV3.0.1COPYRIGHT & TRADEMARKS FCC STATEMENT CE Mark WarningSafety Information Product Description AV200 Nano Powerline Adapter EN EN EN 61000-3-22006+A12009+A22009 EN ENEN60950-12006+A112009+A12010+A122011 Yang Hongliang Product Manager of International BusinessCONTENTS Chapter 5 Advanced Feature How to Use the Pair ButtonsPackage Contents TL-PA210 AV200 Nano Powerline Adapter1.3 Important Safety Instructions Chapter 1 Introduction1.1 Conventions 1.2 System Requirement¾ If liquid has been spilled on the product Chapter 2 Connecting Mechanism 2.2 LED Indicator2.1 Introduction Status2.3 Physical Interface TL-PA210Interface Description2.4 Connection Instruction 2.5 Hardware Connection - Computer2.6 Hardware Connection - Internet TL-PA210 AV200 Nano Powerline Adapter Chapter 3 Installing Management Utility TL-PA210 AV200 Nano Powerline Adapter TL-PA210 AV200 Nano Powerline Adapter TL-PA210 AV200 Nano Powerline Adapter Chapter 4 Using the Management Utility 4.1 Status4.2 Network 4.1.1 Set Local Device’s Network Name4.2.1 Rename the Remote Device/Enter Password Password is unnecessary to enter for renaming 4.2.2 Add Device4.3.1 Upgrade Firmware 4.3 System4.3.2 Reset Device To upgrade the devices firmware, follow these instructions4.3.3 Set All Devices’ Network Name Chapter 5 Advanced Feature How to Use the Pair Buttons 5.2 Set Up a Powerline AV Network with the Pair ButtonCreate a Powerline network using the Pair button： 5.1 Pair Secure with 128 bits-AESLeave an existing Powerline AV Network Join an existing Powerline AV NetworkThe sequence of Step 1 and Step 2 can be exchanged Appendix A Troubleshooting 1. The Power LED does not light up. Ans. Check the following3. The Powerline LED does not light up 2. The Ethernet LED does not light up