ZyXEL Communications 100IH manual Default Dial-In Setup, Menu 13 Default Dial-in Setup

Page 82

Prestige 100 and 100IH ISDN Router and Router/Hub

6.3Default Dial-In Setup

This section covers the default dial-in parameters. The parameters in Menu 13 affect incoming calls from both remote dial-in users, and remote nodes until authentication is completed. Once authentication is completed and if it matches a remote node, your Prestige will use parameters from that particular remote node.

Menu 13 - Default Dial-in Setup

Telco Options:

IP Address Supplied By:

CLID Authen= None

Dial-in User= Yes

 

IP Pool= No

PPP Options:

IP Start Addr= N/A

Recv Authen= CHAP/PAP

IP Count(1,2)= N/A

Compression= Yes

 

Mutual Authen= No

 

PAP Login= N/A

 

PAP Password= N/A

 

Multiple Link Options:

 

Max Trans Rate= 128

Session Options:

 

Callback Budget Management:

Edit Filter Sets= No

Allocated Budget(min)=

 

Period(hr)=

 

Press ENTER to CONFIRM or ESC to CANCEL:

Press Space Bar to Toggle.

Figure 6-3 Menu 13 – Default Dial-in Setup

From the Main Menu, enter 13 to go to Menu 13 – Default Dial-in Setup. This section describes how to configure the protocol-independent fields in this menu. For the protocol- dependent fields, refer to the appropriate chapters.

The table below describes and contains information on how to configure each parameter in Menu 13 – Default Dial-in Setup.

6-4

Dial-In Server Configuration

Image 82
Contents ZyXEL Prestige 100 and 100IH ECC Interference Statement Iii ZyXEL Limited Warranty Customer Support Page Table of Contents Chapter Dial-in Server Configuration Chapter Remote Node ConfigurationChapter Remote Node TCP/IP Configuration Chapter Advanced Phone Services11-1 10-1Index Table of Contents Internet Access Application List of FiguresXii List of Figures/Tables Xiii List of Tables Generic Filter Rule Menu Fields Preface About Your PrestigeStructure of this Manual Page Features of the Prestige Getting to Know Your Isdn RouterAUI Interface P100 only Upgrade P100IH Firmware via LAN Applications for Prestige 100 and 100IH Internet AccessLAN-to-LAN Connection Remote Access Server LAN-to-LAN Connection ApplicationTelecommuting/Remote Access Server Application Hardware Installation & Initial Setup Front Panel Leds of P100Front Panel LEDs of P100IH Front Panel Of P100IH LED functionsPrestige 100IH Rear Panel and Connections Prestige 100IH Rear Panel and ConnectionsPrestige 100 Rear Panel and Connections UTP Interface Additional Installation Requirements Power On Your Prestige Power-On DisplayNavigating the SMT Interface Main Menu CommandsOperation Press/read Description Main Menu Summary System Management Terminal Interface SummaryMenu Title Description Changing the System Password Menu 23.1 System PasswordGeneral Setup Menu 1 General SetupSPIDs, Phone #’s, Switch Types Isdn Setup MenusGeneral Setup Menu Fields Switch Type Geography No of Phone #s No of SPIDsNorth American Isdn Setup Menus 10 North American Isdn SetupNorth American Isdn Menu Setup Fields Menu 2.1 fields NI-1 Default Feature Key SettingsNone European DSS1 & German 1TR6 Isdn Setup Menus MSN and SubaddressOutgoing Calling Party Number 10 Menu 2 Isdn Setup Outgoing Calling Party Number otherwise, leave it blankIncoming Phone Number Matching is Don’t Care IgnoreEthernet Setup 15 Loopback testProtocol Dependent Ethernet Setup General Ethernet SetupPage TCP/IP Parameters Chapter Internet AccessFactory Ethernet Defaults IP Address and Subnet MaskRIP Setup Dhcp ConfigurationIP Pool Setup TCP/IP Ethernet Setup and Dhcp Menu 3.2 TCP/IP and Dhcp Ethernet SetupDhcp Ethernet Setup Menu Fields Only/Out Only TCP/IP Ethernet Setup Menu Fields2B/RIP-2M Both Internet Access Configuration Internet Account InformationMenu 4 Internet Access Setup Internet Access Setup Menu Fields FieldSingle User Account Single User Account TopologyAdvantages of SUA Single User Account Menu Fields Single User Account ConfigurationField Description Configure a Backup ISP Configuring Backup ISP AccountsTo Switch ISP Page Remote Node Setup Chapter Remote Node ConfigurationRemote Node Profile Menu 11 Remote Node Setup Yes/No Remote Node Profile Menu FieldsField Description Options OutgoingEnable Yes thenLeased Outgoing Authentication Protocol64k Allocated Budget and Period do not applyBandwidth on Demand PPP MultilinkBTR v MTR for BOD Editing PPP Options Menu 11.2 Remote Node PPP OptionsRemote Node PPP Options Menu Fields Remote Node Filter Menu 11.5 Remote Node FilterPage Remote Node TCP/IP Configuration LAN-to-LAN ApplicationRemote Node Setup Menu 11.3- Remote Node TCP/IP OptionsTCP/IP related fields in Remote Node Profile YesOnly /Out Only TCP/IP Remote Node Configuration2B/RIP-2M Static Route Setup Example of Static Routing TopologyMenu 12.1 IP Static Route Setup Edit IP Static Route Menu Fields Page Remote Dial-in Users/Remote Nodes Comparison Chart Chapter Dial-in Server ConfigurationRemote Dial-in Users Remote Nodes Remote Access Server Telecommuting Remote UserLAN-to-LAN Server Application Example of a LAN-to-LAN Server ApplicationDefault Dial-In Setup Menu 13 Default Dial-in SetupRequired Default Dial-in Setup FieldsPreferred Dial-In IP Address Supplied By Dial-in User is set to Dial-In Users Setup Default Dial-in FilterMenu 14 Dial-in User Setup Optional Edit Dial-in User Menu FieldsMandatory Clid Authentication CallbackConfiguring a Server behind SUA Multiple Servers behind SUAMultiple Server Configuration Services vs. Port numberChapter Advanced Phone Services Supplemental Services by regionSupplemental Services by switch type Setting Up Supplemental Phone ServiceGetting Started Call Waiting How to use call waitingFlash Key Three Way CallingHow To Use Call Transfer How To Use Three Way CallingCall Transfer Reminder Ring Phone Flash CommandsCall Forwarding To Do a Blind TransferPage Chapter Filter Configuration About FilteringFilter Structure of the Prestige Configuring a Filter Set Menu 21 Filter Set ConfigurationAbbreviations Used in the Filter Rules Summary Menu Filter Rules Summary MenuAbbreviations Description Display Abbreviations Used If Filter Type Is IP Abbreviation DescriptionAbbreviations Used If Filter Type Is GEN Configuring a Filter Rule 1 TCP/IP Filter RuleMenu 21.1.1 TCP/IP Filter Rule Equal/Not Equal TCP/IP Filter Rule Menu FieldsNone/Less/Greater Yes / N/ACheck Next Rule Action MatchedAction Not Matched ForwardGeneric Filter Rule Menu 21.1.2 Generic Filter RuleGeneric Filter Rule Menu Fields Ethernet traffic Applying a Filter and Factory DefaultsCheck Next Rule Forward Drop Remote Node Filters Filtering Remote Node trafficAbout Telnet Configuration Telnet Configuration and CapabilitiesTelnet Under SUA System Timeout Single AdministratorTelnet Capabilities Chapter System Maintenance Menu 24 System MaintenanceMenu 24.1 System Maintenance Status System StatusSystem Maintenance Status Menu Fields ALULAN Packet That Triggered Last Call System Maintenance Information System InformationModified in Menu 1 General Setup Fields in System MaintenanceConsole Port Speed Viewing Error Log Log and TraceExamples of Error and Information Messages Syslog And Accounting System Maintenance Menu Syslog ParametersParameter Description Error Information Messages Diagnostic Menu 24.4 System Maintenance DiagnosticSystem Maintenance Menu Diagnostic This figure shows an example where authentication failed Restore Configuration Backup ConfigurationSoftware Update Boot module commands 11 Menu 24.7 Software UpdateCommand Interpreter Mode Call Control14 Menu 24.9 System Maintenance Call Control Call Control ParametersBlacklist Call Control Parameters FieldsBudget Management Call History18 Call History Call History FieldsTroubleshooting the Start-Up of your Prestige Chapter TroubleshootingProblems Starting Up the Prestige Problem Corrective ActionProblems With the Isdn Line Troubleshooting the Isdn LineProblems Connecting to a Remote Node or ISP Problems with the LAN InterfaceProblems for Remote User to Dial-in Page Appendix Acronyms and AbbreviationsPAP Index IndexSubnet mask, 3-2, 3-6, 5-4
Related manuals
Manual 140 pages 54.37 Kb Manual 67 pages 10.23 Kb Manual 5 pages 9.28 Kb