CS@ 3000G Features
•19”
•Automatic
•Separate power transformers/circuit breakers for each channel
•Independent channel thermal/fault protection
•DDT’” activation LED and power LED, each channel
•Calibrated/detented input attenuator controls, each channel
•Two recessed, balanced input transformer sockets for
•Single XLR and dual phone plug inputs, each channel
•XLR input can be transformer balanced
•Dual phone plug and
•Rear panel DDT’” defeat, mode select, and ground lift switches
Peavey Electronics is proud to announce the introduction of a new line of exciting professional power amplifiers. The new
These new designs use a new class of operation called “Class BG”. This class uses two levels of power supply “rails,” but switches between the rails faster and at lower distortion levels than does a typical Class G design. This unit then combines higher efficiency and lower distortion, and together with our all new Nonsaturating Series Single Emitter Resistor topology (NSSER), provides awesome performance levels with full power 20 kHz distortion below 0.04%, and with slew rates greater than 40 V&Sec. This technology is called “Dynamic Logic” and is covered by a U.S. Patent (pending).
The following is the new CS 3000G specs:
1000 W RMS into 4 ohms; 1500 W RMS into 2 ohms, per channel 2000 W RMS into 8 ohms; 3000 W RMS into 4 ohms (Bridge mode) Slew Rate: 40 V/microsecond, Sstereo mode, each channel Frequency Response: 20 Hz to 20 kHz, +0.2 dB, at rated power Total Harmonic Distortion: Less than 0.04%, at rated power
Hum and Noise: 100 dB below rated power, unweighted
The unit is attractively packaged in a rugged,
3