Kramer Electronics VP-725NA user manual

Up to four component video (sometimes called YUV, or Y, B-Y, R-Y, or Y, Pb/Cb, Pr/Cr) sources or four RGB sources to the four sets of 3 BNC connectors, G/Y, B/Pb, and R/Pr.

For example, an HDTV satellite receiver to COMP IN 1 and an RGB camera connected to COMP IN 4.

Up to four HDMI sources (for example, DVD players) to the HDMI connectors

2.Connect one or more of the following balanced stereo audio sources (not illustrated in Figure 3):

UXGA sources 1 to 4 to the UXGA AUDIO INPUT terminal block connectors (from 1 to 4)

CV sources 1 to 4 to the CV AUDIO INPUT terminal block connectors (from 1 to 4)

s-Video sources 1 to 4 to the YC AUDIO INPUT terminal block connectors (from 1 to 4)

Component video/ RGB sources 1 to 4 to the COMP AUDIO INPUT terminal block connectors (from 1 to 4)

3.Connect a microphone to the Mic IN XLR connector, and push in or release the Dyn/Con switch as appropriate.

4.Connect the CV OUT BNC connector, and the UXGA OUT 15-pin HD connector to the respective video inputs on the projector. Connect the respective AUDIO OUTPUT terminal block connectors (CV and UXGA) to balanced audio acceptors (for example, audio amplifiers).

5.Connect the COMP OUTPUT BNC connectors: G/Y, B/Pb, and R/Pr to the respective component video inputs on the LCD monitor.

6.Connect up to three SCALED OUTPUTS, as follows:

Connect the RGBHV connectors (G/Y, B/Pb, R/Pr, H, and V) to the RGBHV acceptor (for example, a projector)

Connect the HDMI connector to the HDMI acceptor (for example, an LCD display)

VP-725NA - Connecting the VP-725NA Presentation Switcher/Scaler 15