7.1.4The Geometry Screen
Figure 20 defines the Geometry screen, allowing the user flexibility in positioning his projector relative to the screening surface.
Figure 20: Geometry Screen
Geometry Screen
Setting | Function |
|
|
Default
Application | Select the output application: Keystone, Anyplace or | Keystone |
| Rotation |
|
Location | Select the location of the display: Front, Ceiling, Rear or | Front |
| Rear ceiling |
|
Horizontal | Adjust the horizontal keystone: | 0 |
Keystone | If the projector is located at an angle to the left or right of the |
|
| screen |
|
Vertical Keystone | Adjust the vertical keystone: | 0 |
| If the projector is located at an angle above or below the screen |
|
Diagonal | Move the location of each corner of the display separately, | Top Left |
Projection | horizontally and vertically: Top Left, Top Right, Bottom Left, |
|
| Bottom Right or Reset (to reset diagonal projections |
|
| settings) |
|
Pincushion/Barrel | Adjust the pincushion or barrel appearance of the screen: - | 0 |
| 20 to 20 |
|
| For projection onto curved surfaces |
|
Rotation | Rotate the display clockwise or counterclockwise (in 1° | 0 |
| increments): |
|
Reset all | Resets the geometry settings to their default values |
|
Available settings for each application are listed here:
Application
Available Settings
|
| Keystone | Location, horizontal keystone, vertical keystone, pincushion/barrel and |
|
|
| Reset all |
|
| Anyplace | Location, Diagonal Projection and Reset all |
|
| Rotation | Location, pincushion/barrel, Rotation and Reset all |
|
|
|
|
38 |
|
| |
|
|
|
|