Kramer Electronics user manual Connecting to the VP-725NA Presentation Switcher/Scaler

Page 21

Connect the UXGA connector to the UXGA acceptor, for example, a monitor (not illustrated in Figure 3)

7.Connect the MASTER OUT terminal block connector to the balanced audio input on the audio amplifier, and route the audio input (corresponding to the converted video input) to the MASTER OUT.

8.Connect the power cord (not illustrated in Figure 3).

We recommend that you use only the power cord that is supplied with this machine.

9.If required connect:

A PC (see Section 5.3).

The Ethernet port (see Section 5.4).

Figure 3: Connecting to the VP-725NA Presentation Switcher/Scaler

16	VP-725NA - Connecting the VP-725NA Presentation Switcher/Scaler

Image 21

Contents VP-725NA Page Page Contents Figures Introduction Achieving the Best Performance Getting StartedHdtv Compatibility and Hdcp compliance OverviewVP-725NA Overview Defining Edid About Hdmi About Hdcp Defining the VP-725NA Presentation Switcher/ScalerVP 725NA USB Front Panel Feature FunctionMIC Control Audio Input Rear Panel Feature FunctionComp Output BNC Installing in a Rack Connecting the VP-725NA Connecting the VP-725NA Presentation Switcher/ScalerPage Connecting to the VP-725NA Presentation Switcher/Scaler Connecting to the VP-725NA via RS-232 Rgbs and RGsB PinoutsRgbs and RGsB Pinouts Input Color Space Straight Cable RS-232 Connection with a Null Modem Adapter Connecting the VP-725NA via the Ethernet portClick OK Connecting the Balanced/Unbalanced Stereo Audio Input/Output Using the Operating Modes Operating the VP-725NA Presentation Switcher/ScalerDefinition Five Independent One Scaler SwitchersSwitching the VP-725NA as Five Independent Switchers Switching an Input to an OutputUnderstanding the Audio Features Switching the VP-725NA as a ScalerAdjusting the Audio Level Adjusting the Audio Input and Audio Output Levels Using the Microphone Control Modes Understanding the PIP FeaturePIP Source Main SourceLocking and Unlocking the Front Panel Activate the PIP Feature byDisplaying a Blank Screen Freezing the ImageConfiguring the VP-725NA via the OSD Menu Screens Configuring and Controlling the VP-725NAInput Screen Input Screen Setting Function DefaultPicture Screen Picture Screen Setting Function DefaultOutput Screen Output Screen Setting Function Selection/Range DefaultVirtual Wide Selecting the Correct Aspect Ratio PIP Screen PIP Screen Setting Function DefaultAudio Screen Audio Screen Setting Function DefaultAudio Level Screen Geometry Screen Setting Function Default Application Available SettingsGeometry Screen Setup Screen Setting Function Default Setup ScreenHdcp Slideshow FeatureAdvanced Setup Screen Mode Set Functions Setting Selection/Range DefaultOSD Functions Setting Selection/Range Default Obtained via the Capture function or downloaded via USB Misc Setup Screen Setting Function DefaultInput Setup Screen Setting Function Range Default Input Setup ScreenOutput Functions Setting Default Output Setup ScreenActive Video Functions Info ScreenOperating via ETHERNET/Serial Port Operating via the LCD DisplayKey Function Operating via the Infrared Remote Control TransmitterDefines the Text Overlay Application Screen Using Text OverlayText Overlay Application Screen Feature FunctionInputs Technical SpecificationsTechnical Specifications of the Y/C, Video Signal Technical Specifications of the Component Input Signal Technical Specifications of the HDMI/DVI/RGB Output Signal 10 VP-725NA Communication Protocol Secam Communication Protocol of the VP-725NAOutput Hdmi Type Zoom Geometry Diagonal Projection Reset Communication Protocol of the VP-725NA Swap Communication Protocol of the VP-725NA Communication Protocol of the VP-725NA Communication Protocol of the VP-725NA Max Off 25 for Get Command Error Codes Error CodesVP-725NA VP-725NA Communication Protocol Safety Warning