Connecting to the Media / Room Controller Equipment
7.1Setting the Media / Room Controller PROGRAM Dipswitches
The PROGRAM dipswitches are located in the CONTROLLER area of the rear panel (see section 7 .1). Table 6 defines the PROGRAM dipswitch settings:
Table 6: PROGRAM Dipswitch Settings
DIPS | Description |
1ON for Firmware Upgrade (see section 10 .2)
2Not used
3ON for Factory Reset (see section 7 .1.1)
4Not used
7.1.1Factory Reset
Factory reset clears all the button macro configurations1, serial ports definition and also returns the IP number, Gateway and Net mask to their preset default settings2.
Warning: Factory Reset erases all the configured button macros
To reset the Media/Room Controller to its default settings, do the following:
1.Turn the power on the
2.Set DIP 3 ON.
3.Turn the power on the
The machine initializes after about 5 seconds
4.Set DIP 3 OFF.
1 On the Media/Room Controller buttons as well as on the Presentation Switcher SELECTOR buttons 2 IP number: 192.168.1.39, Gateway: 0.0.0.0, and Net mask: 255.255.0.0
21