Kramer Electronics VP-23RC Presentation Switcher Section Operation, Independent Switchers Mode

Operating Your VP-23RC

If you want to stop a macro sequence, press and hold that button for 5 seconds. The sequence will come to an end. You can resume operation by pressing any button1. The unit will carry out the macro sequence commands from the beginning.

9.3.4Turning the Light of the Backlit Buttons On and Off

When the room is darkened, the buttons can be illuminated for convenience. To turn on the backlight, press buttons 3 and 7 simultaneously

To turn off the backlight, press the respective buttons once again.

9.4The Presentation Switcher Section Operation

The Presentation Switcher section has two operation modes:

￿The Independent Switchers mode (see section 9￿ .4.1)

￿The Master Audio mode (see section 9￿ .4.2)

In both operation modes, if configured, the SELECTOR buttons, once pressed, execute a sequence of configured commands (see section 9￿ .4.3).

9.4.1The Independent Switchers Mode

In the independent switchers mode, the three switchers of the VP-23RCoperate independently from each other, as illustrated in Figure 20 (the Media/Room Controller connections are not shown in this illustration). You can route one of the 4 CV inputs, one of the 4 Y/C inputs and one of the 4 VGA/UXGA inputs to the corresponding CV, Y/C and UXGA2 outputs, respectively.

To switch an input to an output3:

￿Press one4 button from the set of four buttons in the VIDEO (CV)-AUDIO SELECTOR section and/or5

￿One button from the set of four buttons in the s-VIDEO (Y/C)-AUDIO SELECTOR section and/or5

￿One button from the set of four buttons in the VGA/UXGA-Audio SELECTOR section

1 Including the button you kept pressed to stop the macro sequence 2 And to the UXGA CAT5 OUT connector (audio excluded)

3 Assuming that all inputs are connected

4 You cannot select more than one button in a section

5 You can overlook a section and choose not to select a button from it

34 KRAMER: SIMPLE CREATIVE TECHNOLOGY