IOGear GCS1802, GCS1804 user manual

Page 43

4.Enter OSD select F6, key down to “Firmware Upgrade” then [Enter] or Click. Or Key in Y (Yes) on the bottom of the display window and press [Enter].

The “FIRMWARE UPGRADE IN PROGRESS” message will begin ﬂashing on the screen.

The front panel LEDs ﬂash together to indicate ﬁrmware upgrade mode is in effect.

The utility searches the computer attached to the ﬁrmware upgrade port for the ﬁle, and when found it is displayed in the Firmware Upgrade Utility under Device List.

Image 43

Contents Installation Guide Page Table of Contents Package Contents Console RequirementsComputers Cables Connector Cable LengthMAC Supported Operating SystemsGCS1804 Front View HardwarePage GCS1802 Rear View GCS1804 Rear View Page Cable Connection Hardware SetupPage Installation Diagram PS/2 Port Numbering Before you beginPage Manual Operation Pushbutton operation Default methodHotkey Operation Page Port Switching Result Hotkey sequence Auto Scanning Skip ModeTo exit Skip, press Esc or Spacebar OSD Overview OSD OperationKVM USB Moves the highlight bar up Moves the highlight bar down OSD Navigation F1 KVM OSD FunctionsF3 Audio F6 SET Page Page Page Screen Blanker Default and Alternate manual switch settings Setting Default settings for the On Screen DisplayKeyboard Emulation Sun Keyboard Firmware Upgrade Utility Page Page Starting the Upgrade Page Upgrade Failed Page Troubleshooting Symptom Technical Support Warranty Information Important Product Information Limited Warranty StatementMake sure you Federal Communications Commission FCC Statement Page CE Statement IOGEAR, INC ContactFUN