IOGear GCS1804, GCS1802 user manual Cables, Connector Cable Length

Page 6

Cables

Only cable sets specifically designed to work with this switch may be used to link the computers. Two 6 ft USB cables sets are provided with the GCS1802. Two 4ft USB cables and two 6ft USB cables are provided with the GCS1804.

Both switches also support computers that use PS/2 keyboards and mice. Cable sets with PS/2 connectors, as well as longer cable sets are available from your dealer. See the following table for details:

Connector

Cable Length

Part Number

USB (2.0)

4 ft

G2L-5301U

USB (2.0)

6 ft

G2L-5302U

PS/2

4 ft

G2L-5301P

PS/2

6 ft

G2L-5302P

Note: The GCS1802 [GCS1804] USB peripheral sharing works only with USB cable sets. It will not work with the PS/2 cable sets.

6

Image 6
Contents Installation Guide Page Table of Contents Package Contents Requirements ConsoleComputers Connector Cable Length CablesSupported Operating Systems MACHardware GCS1804 Front ViewPage GCS1802 Rear View GCS1804 Rear View Page Hardware Setup Cable ConnectionPage Installation Diagram PS/2 Before you begin Port NumberingPage Pushbutton operation Default method Manual OperationHotkey Operation Page Port Switching Result Hotkey sequence Skip Mode Auto ScanningTo exit Skip, press Esc or Spacebar OSD Operation OSD OverviewKVM USB Moves the highlight bar up Moves the highlight bar down OSD Navigation OSD Functions F1 KVMF3 Audio F6 SET Page Page Page Screen Blanker Default and Alternate manual switch settings Default settings for the On Screen Display SettingKeyboard Emulation Sun Keyboard Firmware Upgrade Utility Page Page Starting the Upgrade Page Upgrade Failed Page Troubleshooting Symptom Technical Support Limited Warranty Statement Warranty Information Important Product InformationMake sure you Federal Communications Commission FCC Statement Page CE Statement Contact IOGEAR, INCFUN