IOGear GCS1804, GCS1802 user manual Starting the Upgrade

Page 44

Starting the Upgrade

1.Run the downloaded Firmware Upgrade Package ﬁle – either by double clicking the ﬁle icon, or by opening a command line and entering the full path to it.

The Firmware Upgrade Welcome screen appears

2.Read the License Agreement (Click on the I Agree radio button).

3.Click Next to continue. The Firmware Upgrade Utility main screen appears. The Utility inspects your installation. The KVM will be listed in the Device List panel.

4.High Light the KVM, then click Next to perform the upgrade.

44

Image 44

Contents Installation Guide Page Table of Contents Package Contents Computers RequirementsConsole Connector Cable Length CablesSupported Operating Systems MACHardware GCS1804 Front ViewPage GCS1802 Rear View GCS1804 Rear View Page Hardware Setup Cable ConnectionPage Installation Diagram PS/2 Before you begin Port NumberingPage Pushbutton operation Default method Manual OperationHotkey Operation Page Port Switching Result Hotkey sequence Skip Mode Auto ScanningTo exit Skip, press Esc or Spacebar OSD Operation OSD OverviewKVM USB Moves the highlight bar up Moves the highlight bar down OSD Navigation OSD Functions F1 KVMF3 Audio F6 SET Page Page Page Screen Blanker Default and Alternate manual switch settings Default settings for the On Screen Display SettingKeyboard Emulation Sun Keyboard Firmware Upgrade Utility Page Page Starting the Upgrade Page Upgrade Failed Page Troubleshooting Symptom Technical Support Make sure you Limited Warranty StatementWarranty Information Important Product Information Federal Communications Commission FCC Statement Page CE Statement Contact IOGEAR, INCFUN