Installation
Before you Begin
1.You must unplug the power cords of any computers that does not support
2.To prevent damage to your installation make sure that all devices on the installation are properly grounded.
Single Stage Installation
To set up the single stage installation of GCS1758, refer to the installation diagrams on the following page, and do the steps as indicated:
1. Plug your USB keyboard, USB mouse, monitor, microphone and speakers into the Console USB
Ports located on the unit’s rear panel.
10
2.Using a KVM cable set, plug the custom SPDB15 connector into any available CPU Port on the switch and plug the accompanying microphone and speaker cables into the CPU Port’s microphone and speaker jacks.
Note: Be sure that all the plugs are in the same CPU Port sockets (all in Port 1, all in Port 2, etc.).