EtherFast Network Attached Storage (120GB with PrintServer)
The Front Panel
The Network Attached Storage’s LEDs, which indicate status information about network activity, and power button are located on the front panel.
Ready/Status | Green or Orange. This LED is solidly lit green when the Network Attached Storage is working |
| properly. It flashes during |
| is orange, there is an error. |
LAN | Green or Orange. The LAN LED serves two purposes. If the LED is continuously lit, the Network |
| Attached Storage is successfully connected to a device through the LAN port. If the LED |
| flashes, it indicates network activity. If the LED is orange, there is a data collision. |
Disk | Green. The Disk LED flashes when the Network Attached Storage is reading or writing data. |
Disk Full | Green. The Disk Full LED lights up when the Network Attached Storage has reached its |
| maximum storage capacity. It flashes when it reaches 98% of total capacity. |
BackUp | Green. The BackUp LED flashes when the Network Attached Storage’s backup utility is active. |
Disk 2 | Green. The Disk 2 LED flashes when Disk 2 is reading or writing data. |
Disk 1 | Green. The Disk 1 LED flashes when Disk 1 is reading or writing data. |
Power Button | If the Network Attached Storage is powered off, you can start it up by briefly pressing the |
| power button. To power down the Network Attached Storage, press the power button, and its |
| internal shutdown process will begin. The Network Attached Storage must be powered off this |
| way, or through the Administration - Status tab of the |
| Configuring the Network Attached Storage”). |
Chapter 2: Getting to Know the Network Attached Storage
Figure 2-2: Front Panel
5
The Front Panel