Linksys EFG120 manual Beeper Codes, Minutes after the first beep

Page 13

EtherFast Network Attached Storage (120GB with PrintServer)

The Beeper Codes

The Network Attached Storage has an internal beeper that beeps to indicate certain events.

1	Beep	This signals that the Reset button or power button has been pressed.
2	Beeps	When this is repeated every five seconds for one minute, it signals that the Network Attached
		Storage is configured as a DHCP client, but no DHCP server has responded to the DHCP client’s
		request for an IP address.
3	Beeps	When this is repeated every 15 seconds for three minutes, it signals that the Network Attached
		Storage’s hard drive usage exceeds 98% of total capacity.
5	Beeps	When this is repeated every 15 seconds for three minutes, it signals that the Network Attached
		Storage is overheating. The Network Attached Storage will automatically shut down three
		minutes after the first beep.

Chapter 2: Getting to Know the Network Attached Storage

6

The Beeper Codes

Image 13

Contents Network Attached Storage Copyright and Trademarks How to Use this GuideTable of Contents EtherFast Network Attached Storage 120GB with PrintServer Back Panel List of Figures25 Copy Files Screen Figure B-4 Insert Screw through Left Side of Tray Welcome IntroductionWhat’s in this User Guide? EtherFast Network Attached Storage 120GB with PrintServer Getting to Know the Network Attached Storage Before removing the power adapterLAN Minutes after the first beep Beeper CodesConnect the Ethernet Network Cable Connecting the Network Attached StorageSetup Wizard Setting Up the Network Attached StorageOverview IP Settings Screen Time and Date Settings Screen Review Settings Screen 12 BrightStor ARCserve Backup Welcome Screen Installation of BrightStor ARCserve Backup for Windows14 Customer Information Screen 16 Select Install Type Screen 17 Select Products Screen 19 Set Password Screen 21 Product List Screen 23 Licensing Information Screen 26 Install Summary Screen 27 Registration Screen 32 Purchase Software Screen Access to the Web-based Utility Configuring the Network Attached StorageGigaDrive Status Home Tab User Log in Private Data Home Tab Disk 1 Public Data or Disk 2 Public DataIP Address LAN SettingsDNS Server Dhcp ServerIdentification System InformationLocation Secure IP Address OptionsUsers Information Administration Tab UsersExisting Users PropertiesUser Membership Administration Tab StatusSystem Disk PrinterMail Alerts Group Information Administration Tab Advanced GroupsNew Group Existing GroupsShares Information Administration Tab Advanced SharesExisting Shares Backup Settings Administration Tab Advanced BackupData Backup Config BackupDisk Settings Administration Tab Advanced DiskFormat Disk Self-test S.M.A.R.TStandby DefragAdministration Tab Advanced Setup Administration Tab Advanced UpgradeUpgrade Settings User Guide TabAppendix a Troubleshooting Print job does not print and no error message is displayed Figure B-2 Attach Power Cable Appendix B Installing a Second Hard DriveFigure B-4 Insert Screw through Left Side Tray Figure B-6 Access the Web-based Utility Figure B-7 Format Disk Figure C-1 Click Start Button Appendix C Setting Up the Built-in PrintServerFigure C-4 Welcome to the Add Printer Wizard Screen Figure C-5 Local or Network Printer Screen Figure C-8 Select Your Printer Figure C-10 Change Printer Properties Shared Resources Appendix D Windows HelpNetwork Neighborhood/My Network Places Appendix E Glossary EtherFast Network Attached Storage 120GB with PrintServer 10/100/1000 Mbps RJ-45, 1 DB-25 Parallel Port Appendix F SpecificationsLimited Warranty Appendix G Warranty InformationFCC Statement Appendix H Regulatory InformationNeed to contact Linksys? Appendix I Contact InformationInformation section in this Guide