Canon LV-7325U owner manual SETTING-UP the Projector, Positioning the Projector, Adjustable Feet

PREPARATION

SETTING-UP THE PROJECTOR

POSITIONING THE PROJECTOR

●This projector is designed to project on a flat projection surface.

●The projector can be focused from 4.6’(1.4m) ~ 35.4’(10.8m).

●Refer to the figure below to adjust the screen size.

35.4’ (10.8m)

				24.0’ (7.3m)	300”
			18.0’ (5.5m)
		11.8’ (3.6m)		200”
4.6’ (1.4m)		100”	150”	154”	231”
	40”	77”	115”
	30”

H1

H2

Screen Size	30”	60”	100”	150”	200”	300”
(W x H) mm
	610 x 457	1219 x 914	2032 x 1524	3048 x 2286	4064 x 3048	6096 x 4572
Height (H1)	17.1”(435mm)	34.3”(870mm)	57.1”(1451mm)	85.7”(2177mm)	114.3”(2903mm)	171.4”(4354mm)
Height (H2)
	0.9”(22mm)	1.7”(44mm)	2.9”(73mm)	4.3”(109mm)	5.7”(145mm)	8.6”(218mm)

ROOM LIGHT

The level of brightness in a room has a great influence on picture quality. It is recommended to limit ambient lighting in order to provide the best image.

ADJUSTABLE FEET

Picture tilt and projection angle can be adjusted by rotating the ADJUSTABLE FEET. Projection angle can be adjusted to 10 degrees.

1	Lift the front of the projector and pull the FEET LOCK
	LATCHES on both sides of the projector.
2	Release the FEET LOCK LATCHES to lock the
	ADJUSTABLE FEET and rotate the ADJUSTABLE
	FEET to fine tune the position and the tilt.
3	To shorten the ADJUSTABLE FEET, lift the front of the
	projector and pull and undo the FEET LOCK LATCHES.

The position and the keystone distortion of the image can also be adjusted using the Menu Operation. (Refer to pages 21, 29, 30 and 37.)

ADJUSTABLE FEET

FEET LOCK LATCHES

7