Remote control
Using the remote control
CAUTION ►Be careful in handling the remote control.
•Do not drop or expose the remote control to physical impact.
•Do not get the remote control wet or place it on wet objects. It may result in malfunction.
•Remove the batteries from the remote control and store them in a safe place if you won’t be using the remote control for an extended period.
•Replace the batteries whenever the remote control starts malfunctioning.
•When strong lights (such as direct sunlight) or light from an extremely close range (such as from an inverter fluorescent lamp), hit the projector’s remote sensor, the remote control may cause to function. Adjust the direction of the projector to keep the light from directly hitting the projector’s remote sensor.
The signal settings for the remote control transmitter and the projector's remote sensor can be changed. If the remote control does not function properly try changing the signal setting.
Changing the signal setting for the remote control transmitter (1)Setting 1 (FREQ. : NORMAL)
Simultaneously press and hold the MUTE and RESET buttons for about 3 seconds. (2)Setting 2 (FREQ. : HIGH)
Simultaneously press and hold the MAGNIFY OFF and ESC buttons for about 3 seconds.
•Setting 1 is the factory default setting.
•When the batteries are removed from the remote control,
Changing the signal setting for the projector's remote sensor
Switch between Setting 1 and 2 using the SERVICE/REMOTE FREQ. item found in OPTION MENU. (43)
If the remote control does not seem to function properly, try changing the settings for the remote control and the projector's remote sensor.
The remote control will not function properly if the remote control transmitter settings and the projector's remote sensor settings are not the same.
The remote control works with the projector’s remote sensor.
30º 30º
approx. 3 meters
•The range of the remote sensor is 3 meters with a 60 degree range (30 degrees to the left and right of the remote sensor).
•Also a remote signal reflected in the screen etc. may be available. If it is difficult to send a remote signal to the sensor directly, please try to use the reflected signal.
•Since the remote control uses infrared light to send signals to the projector (Class1 LED), be sure to use the remote control in an area free from obstacles that could block the remote control’s output signal to the projector.
16