Canon 7365 user manual ❸ Part Names of the Projector, Front/Top, Rear

1. Introduction

❸Part Names of the Projector

Front/Top

Zoom Lever (See page 28)

Controls (See page 6)

Focus Ring (See page 28)

Remote sensor (See page 10)

Adjustable Tilt Foot Lock Button (See page 27)

Adjustable Tilt Foot (See page 27)

Lens

ENOT

SYEK

UNEM

KCAB			Ventilation (inlet) / Filter Cover
LOV+
LOV-			(See page 56)
CP	TOUA
TUPNI
	RE		P
	WOP		MAL
		GNIN	Do not block this vent.
		RAW
			Troubles or fire can result.
			Two filters on LV-7365/LV-7265/LV-7260
			One filter on LV-X7
			Built-in Security Slot ( )*
			Ventilation (inlet)

Lens Cap

Be sure to remove the lens cap during projection. The cap can deform or fire

can occur.

*This security slot supports the MicroSaver ® Security System. MicroSaver ® is a registered trademark of Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc.

Rear

Terminal Panel (See page 7)

Remote sensor (LV-7365/LV-7265) (See page 10)

					WARNING
					PO
			LAMP		WER
VIDEO					AUTO	INPUT			Monaural Speaker
						-VOL
S-VI
INDEO						PC
IN	L	RT	D			B	ME	NU	(LV-7365/LV-7265: 5W)
AUDIOIN							KEYSTONE
						+VOL
	R	SER
		VICE PO
			AIGIT	AUD	IN-1	ACK			(LV-7260/LV-X7: 1W)
			NALOALIN/	AUDIOOUT
				IO IN
			GIN-2		ANALOG

Ventilation (outlet)

Heated air is exhausted from here.

Do not block this vent. Troubles or fire can result.

AC Input

Connect the supplied power cord’s two-pin plug here, and plug the other end into an active wall outlet. (See page 23)

Main Power Switch

When you plug the supplied power cord into an active wall outlet and turn on the Main Power, the POWER indicator turns orange and the projector is in standby mode.

(See page 24)