Compaq SW3322, SW3324, SW3323 manual Connecting a Terminal to the Console Port

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2-5

Connecting a Terminal to the Console Port

The console port is a serial RS-232 interface port that enables a connection to a terminal for performing switch monitoring and configuration functions. The terminal may be a PC or workstation running terminal emulation software, or a dumb terminal configured as a Data Terminal Equipment (DTE) connection. Alternatively, this port can be connected to an external modem to enable remote dial-in management. If you connect a terminal to the console port prior to powering the switch, you can observe the progress and results of the power-up diagnostics as the switch goes through its initialization process.

The console port connector is configured as a standard IBM AT connection using a male DB-9 (see Table A-1 for pinouts) connector. A standard null modem cable is typically all that is needed to connect to this interface. Any cable connected to the console port must be shielded to comply with emissions regulations and requirements.

NOTE: A null modem cable is not provided with the switch.

To connect the console port to a terminal, do the following:

1.Connect a terminal to the console port using a null modem interface cable (Figure 2-2).

Figure 2-2Connecting a Terminal to the Console Port

Compaq SW3322/SW3323/SW3324 Dual-Speed Switch User Guide