Christie Digital Systems 103-008100-01 user manual Lamp Replacement, Replace Counter on the next

APPENDIX

LAMP REPLACEMENT

When the projection lamp of this projector reaches its end of

life, the LAMP REPLACE indicator lights yellow. If this

indicator lights yellow, replace the projection lamp with a newTOP CONTROL one promptly.

This indicator lights yellow when the projection lamp reaches its end of life.

Replace the projection lamp with a new one promptly.

CAUTION

Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.

CAUTION

For continued safety, replace with a lamp assembly of the same type.

Do not drop the lamp assembly or touch a glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace lamp assembly.

1	Turn off the projector and unplug the AC power cord. Allow
	the projector to cool for at least 45 minutes.
2	Loosen the two (2) screws with a screwdriver and open the
	lamp cover.
3	Loosen the two (2) screws with a screwdriver and pull out the
	lamp assembly by using the built in handle.
4	Replace the lamp assembly with a new one and tighten the
	two (2) screws. Make sure that the lamp assembly is set
	properly. Put back the lamp cover and tighten the two (2)
	screws.
5	Connect the AC power cord to the projector and turn on the
	projector.
6	Reset the Lamp replacement counter (refer to”LAMP
	REPLACE COUNTER” on the next page).

NOTE:

•Do not reset the Lamp replacement counter when the projection lamp is not replaced.

	LAMP COVER
LAMP	HANDLE
ASSEMBLY

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

●	Model No. of your projector	:	103-008100-01
●	Replacement Lamp Type No.	:	003-120188-01
			(Service Parts No. 610 328 7362)

48