BOXLIGHT MP-93i specifications Basic operations, To project the picture

Page 12

Basic operations

To project the picture

4

3

5

2		2	STANDBY/ON	MUTE
		2	FREEZE
			FREEZE
STANDBY/ON			MAGNIFY VOLUME
			MAGNIFY VOLUME
	INPUT		OFF
	INPUT
MUTE			POSITION ON	LASER
			POSITION ON	LASER
	MENU	7
RESET
			RESET	RIGHT
		7	MENU ON	MOUSE ON
		7	BLANK	TIMER
			RGB	VIDEO
			INPUT

1

1		Turn the MAIN POWER switch of the projector on.[ I : ON]
1		• The ON indicator will light up orange.

2		Press the STANDBY/ON button.
2		• The ON indicator blinks (green) during warm-up and then lights (green).
		• Power cannot be turned on even if the STANDBY/ON button is pressed within 60 seconds after
		power is turned off, since the lamp has cooled preparing for next lighting.

	3	Remove the lens cap.

4		Adjust picture size using the projection lens ZOOM knob.
5 Adjust focus using the projection lens FOCUS ring.

6		Power on all connected equipment.
6		The method of connecting various equipment, see on the page 19~27.

7		Press the INPUT button or the INPUT SELECT (VIDEO or
		RGB) button to select the source of the signal to be projected

on the screen.

•The selected signal input is displayed at the bottom right of the screen for 3 seconds.

Example on-screen display

RGB1

12

Image 12

Contents Features ContentsOutline Operating GuideFor the Customers in U.K Video signal cables Power cordBefore use Instructions to UsersDo not look directly at the lens when Lamp is lit Do not install this unit in an unstable placeDo not use power supplies other Than that specified If any abnormality occursBe careful in handling the power cord CleaningHandle the power cord carefully Do not step on this unit or do not put a Heavy object on itWhen you are not going to use For a long time Clean inside the unit at least once two yearsDo not place this unit where it gets hot VolumeContents of shipping box Names and functions of each partRemote control sensor Main Power switch AC in socketVideo input terminal RGB input terminalRemote control transmitter How to insert batteries Remove the battery compartment coverInstallation Example of the projector and screen installationHow to use foot adjusters Basic operations To project the pictureTo turn off the power Indicator lights up orangeStandby mode PLUG&PLAYFreeze Function Magnifying FunctionAdjustments and functions To return to the initial settingMemory function On-screen menus are displayed on the screenSET UP How to use the SET UP menuAdjustment Item Details of adjustment Freeze Magnify Manual OperationAUTO-adjustment AUTO-adjustment Confirm ScreenDuring AUTO-adjustment Adjustment Item Details of adjustmentImage OPTMenu Image serves of the picture inversion Menu OPT. allows you to control communication function etcConnection to the video signal terminals Connection to the RGB signal terminalExample of computer signal Resolution Standard Display Dots KHz TypeInitial set signals Computer/signal Horizontal Timing µsComputer/signal Vertical Timing lines Control signal terminal Pin No RS-232C Mouse PS/2Serial +5VPS/2 mouse ADB Mac mouseSerial mouse Control command table Control command tableCommunication RS232C cable ReferenceControl data table Procedure of getting the Projector status Procedure of setting the Projector statusProcedure of default setting the Projector status Example of command errorExample of system setup Connecting various equipmentAC Inlet Computer Note type ComputerDesk typeCleaning the air filter Air filter Filter coverDo not use with removed air filter How to replace lamp Remove the lamp coverLoosen two screws and pull the handle to remove Lamp Install the lamp cover and fix it using screws Reset the lamp timeLamp Message tableIndicator display Blink in the following casesDimension diagram All dimensions shown in inchesRCA Jack terminal Input terminal Input/Output RCA Jack terminal Terminal