BOXLIGHT MP-93i To turn off the power, Plug&Play, Indicator lights up orange, Standby mode

Page 13

Basic operations (continued)

To turn off the power

3

2

1	1	STANDBY/ON	MUTE
	1
		FREEZE
STANDBY/ON		MAGNIFY VOLUME
		OFF
	INPUT
MUTE		POSITION ON	LASER

MENU

RESET

RESET	RIGHT
MENU ON	MOUSE ON
BLANK	TIMER
RGB	VIDEO
	INPUT

ENGLISH

	1	Press the STANDBY/ON button, for 1 second.
		• The ON indicator blinks orange and the lamp turns off. (About 1 minute later), the fan stops and
		the indicator lights up orange.
		• Press the STANDBY/ON button for short time (less than 1 second), the projector do not set in
		standby mode.

	2	Turn the MAIN POWER switch of the projector off.[ : OFF]

	3	Install the lens cap.

	Caution		• To reduce temperature inside the projector, fan will rotate for about 1 minute after the lamp
			is turned off.

•Do not turn off the MAIN POWER switch during the lamp on because the lamp is damaged.

PLUG&PLAY

This projector complies with VESA DDC1/2B specifications. PLUG&PLAY is a system with computer, peripherals (including projectors), and operating system.

It works when the projector is connected to DDC (Display Data Channel) ready computer that is running an operating system software that incorporates plug & play functionality.

(Only RGB 1)

13

Image 13

Contents Contents FeaturesOutline Operating GuideFor the Customers in U.K Power cord Video signal cablesBefore use Instructions to UsersDo not install this unit in an unstable place Do not look directly at the lens when Lamp is litDo not use power supplies other Than that specified If any abnormality occursCleaning Be careful in handling the power cordHandle the power cord carefully Do not step on this unit or do not put a Heavy object on itClean inside the unit at least once two years When you are not going to use For a long timeDo not place this unit where it gets hot VolumeNames and functions of each part Contents of shipping boxAC in socket Remote control sensor Main Power switchVideo input terminal RGB input terminalRemote control transmitter Remove the battery compartment cover How to insert batteriesExample of the projector and screen installation InstallationHow to use foot adjusters To project the picture Basic operationsIndicator lights up orange To turn off the powerStandby mode PLUG&PLAYMagnifying Function Freeze FunctionTo return to the initial setting Adjustments and functionsMemory function On-screen menus are displayed on the screenHow to use the SET UP menu SET UPAdjustment Item Details of adjustment Freeze Magnify Manual OperationAUTO-adjustment Confirm Screen AUTO-adjustmentDuring AUTO-adjustment Adjustment Item Details of adjustmentOPT ImageMenu Image serves of the picture inversion Menu OPT. allows you to control communication function etcConnection to the RGB signal terminal Connection to the video signal terminalsResolution Standard Display Dots KHz Type Example of computer signalComputer/signal Horizontal Timing µs Initial set signalsComputer/signal Vertical Timing lines Pin No RS-232C Mouse PS/2 Control signal terminalSerial +5VADB Mac mouse PS/2 mouseSerial mouse Control command table Control command tableCommunication RS232C cable ReferenceControl data table Procedure of setting the Projector status Procedure of getting the Projector statusProcedure of default setting the Projector status Example of command errorConnecting various equipment Example of system setupAC Inlet Computer Note type ComputerDesk typeAir filter Filter cover Cleaning the air filterDo not use with removed air filter Remove the lamp cover How to replace lampLoosen two screws and pull the handle to remove Lamp Reset the lamp time Install the lamp cover and fix it using screwsLamp Message tableBlink in the following cases Indicator displayAll dimensions shown in inches Dimension diagramRCA Jack terminal Input terminal Input/Output RCA Jack terminal Terminal