BOXLIGHT FP-95t manual Picture Image Adjustment

Page 38

VIDEO MODE

PICTURE IMAGE ADJUSTMENT

Picture adjustments have been preset at the factory. If you want to change the setting, operate the projector as follows.

1.Press MENU BUTTON and the MAIN MENU DISPLAY dialog box will appear.

2.Press the POINT LEFT/RIGHT BUTTON(s) to select IMAGE and press the SELECT (REAR CLICK) BUTTON. Another dialog box IMAGE ADJUST DISPLAY will appear. This shows the current picture settings.

3.In this dialog box, you can adjust the settings by increasing or decreasing the levels shown as numbers. The items and the range of the levels that you can adjust are summarized in the table below.

4.Press the POINT DOWN BUTTON and a red arrow will appear.

5.Move the arrow to an item that you want to adjust by pressing the POINT UP/DOWN BUTTON(s).

6.To increase the level, point the arrow to and then press the SELECT (REAR CLICK) BUTTON. To decrease the level, point the arrow to and then press the SELECT (REAR CLICK) BUTTON.

7.You may want to store the settings in the memory so that you can recall them later. To store the settings, move the arrow to Stored and then press the SELECT (REAR CLICK) BUTTON. When you have stored the settings, "OK ?" is displayed for confirmation.

8.Move the arrow to Yes and then press the SELECT (REAR CLICK) BUTTON. The stored settings are memorized even if the MAIN ON/OFF is switched off.

9.To quit the MENU, move the arrow to Quit and then press the SELECT (REAR CLICK) BUTTON.

10.If you do not want to store the settings, move the arrow to Quit and then press the SELECT (REAR CLICK) BUTTON. The settings changed remains effective until the MAIN ON/OFF switch is turned off.

11.To recall the settings from the memory that you have stored, move the arrow to Reset and then press the SELECT (REAR CLICK) BUTTON. When you have reset the settings, "OK ?" is displayed for confirmation. Move the arrow to Yes and then press the SELECT (REAR CLICK) BUTTON. You can adjust the settings again if needed.

NOTE : "TINT" will be skipped in the PAL, SECAM, PAL-M and PAL-N mode.

MAIN MENU DISPLAY

IMAGE

ADJUST DISPLAY

TABLE OF PICTURE IMAGE ADJUSTMENT

COLOR

DECREASES

0

 

63

INCREASES

 

TINT

MORE PURPLE

0

 

63

MORE GREEN

 

WHITE BALANCE (R/G/B)

DECREASES

0

 

63

INCREASES

 

CONTRAST

LIGHTER

0

 

63 DEEPER

 

BRIGHTNESS

DARKER

0

 

63

BRIGHTER

 

SHARPNESS

SOFTER

0

 

31

SHARPER

 

 

 

 

 

 

 

38

Image 38
Contents Boxlight To the Owner Important Safety Instructions Table of Contents Features and Design Front of the Projector InstallationName of Each Part of the Projector Rear of the ProjectorPositioning SETTING-UP the ProjectorAdjustable Feet Room LightExhaust Vent AIR Intake Ventrear Side Bottom Side Moving the ProjectorVentilation Power Requirements Projector side Female AC outlet side MaleSide of the Projector Connect the Computer Connecting the ProjectorTerminal of the Projector Video Input JACK-2 Side of the Projector Connect the Video EquipmentVideo Input JACK-1 Video Monitor S-VIDEO Output JackConnecting the Computer Control Port Cable Removal HintConnecting to the Serial Port DB 9-PIN Terminal Connecting to the Monitor Output Terminal Analog HDB 15-PINConnecting to the Audio Monitor Output Variable Jacks HDB 15-PIN TerminalConnecting AN IBM-COMPATIBLE Desktop Computer Speaker L Connecting AN IBM-COMPATIBLE Laptop Computer PS/2 Port Provided Connecting a Macintosh Desktop Computer Connecting a Macintosh Powerbook Computer Connecting to the Audio Monitor Output Jacks Connecting the Video EquipmentConnecting to the S-VHS Video Monitor Output Jack Connecting the Video Equipment Video EquipmentFront Indicators TOP Controls Controls and IndicatorsFront Indicators TOP Controls Before OperationReady Indicator Lamp Replacement IndicatorTemperature Warning Indicator Lamp Power IndicatorLaser Light Window Operation of the Remote ControlWireless Remote Control Unit Video Select Button Timer ButtonComputer Select Button Zoom ButtonRemote Control Battery Installation 1714 Using the Remote Control Unit wireless Wired Remote CableControl the Projector Direct OperationMenu Operation COMPUTER/VIDEO ModeVideo Mode Computer Mode Picture PositionTo Turn on the Projector Basic OperationTurning ON/OFF the Projector To Turn OFF the ProjectorDirect Operation Normal Picture Function Timer FunctionDigital Zoom Function Freeze Picture FunctionMenu Operation Main Menu Display Sound Adjust Sound AdjustmentLanguage Adjustment Click ButtonVideo Source Select Video ModeColor System Select Main Menu Display Color SystemPicture Image Adjustment Select Rear Click Button Picture Screen AdjustmentMain Menu Display Screen Adjust Computer System Display Current Mode Computer ModePC Adjustment Computer System SelectCompatible Computer Specifications Main Menu Display Auto Image Setting Lighter Deeper Main Menu Display Image AdjustDecrease Increase Darker BrighterPicture Position Adjustment Main Menu Display Position SettingPC Adjustment OK ? PC Adjustment Display Mode Free Picture Screen Adjustment Other Function Setting Blue Back On or OffRemote Control Code Change Mode 1 or Mode Main Menu Display SettingLamp AGE Appendix Temperature Warning IndicatorAIR Filter Care and Cleaning MeintenanceLamp Cover Lamp Assembly Handle Lamp ReplacementLamp Replacement Indicator Troubleshooting Cleaning the LensService Technical Specifications AV Input JacksBoxlight