USER GUIDE | LCD PROJECTOR |
10.3LAMP REPLACEMENT MESSAGES
When the time is due to replace the lamp, the projector will give you one of the two following messages on the screen.
WARNING!
Lamp has less than 50 hours left of recommended burning time
Please change lamp!
Press any key to clear this message...
The lamp has only 50 hours burning time left, and should be changed. Remember that you can check accumulated lamp usage each time the projector is switched on. A message appears in the lower left hand corner of the screen stating software revision and acumulated lamp hours used.
If you do not respond to the first message, a second message will appear when the lamp has exceeded recommended burning time. Please read Warnings and Notes in Lamp Replacement section carefully and refer lamp change to qualified service personnel only.
WARNING!
Lamp has exceeded its lamp life of 750 hours
Continued use leads to a high risk of lamp explosion
PLEASE CHANGE LAMP IMMEDIATELY ! ! !
After the lamp has been replaced and the lamp timer has been reset, the message below confirms that the operation has been successful.
INFO!
The lamp timer has been reset to 0
Press any key to clear this message...
32